Operation; Pre-Operation Check; Starting Engine; Stopping Engine - MTD 679 cc Manual Del Operador

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

Operation

Pre-Operation Check

The engine is shipped without gasoline and
with oil in the engine. See the Set-Up Section of
this manual for instructions on adding gasoline
and checking oil.

Starting Engine

Turn-Key Ignition
1.
Insert the tractor key into the ignition
module.
2.
Place the PTO/Blade Engage lever to
OFF position.
3.
Engage the tractor's parking brake
.
4.
Push the choke control (if equipped)
upward into the choke on
position.
Note: If the engine is warmed up, it
may not be necessary to place the
choke control in the choke position.
5.
Move the throttle control lever to
midway between the FAST
SLOW
positions.
Note: When operating the tractor
be certain that the throttle lever
is always in the FAST
position. Operating with the throttle
at less than full throttle may lead to
shortened battery life.
6.
Turn the ignition key clockwise to the
START
starts, release the key. It will return to
the NORMAL MOWING
Do NOT hold the key in the START
longer than ten seconds at a time. Doing so may
cause damage to your engine's electric starter.
6.
After the engine starts, deactivate
the choke control (if equipped).
Note: Do NOT leave the choke
control (if equipped) on while
operating the tractor. Doing so will
result in a "rich" fuel mixture and
cause the engine to run poorly.
Stop
Position
and
(rabbit)
position. After the engine
position.
CAUTION
position for
Run
Position
Start
Position
Figure 5-1

Stopping Engine

WARNING!
If you strike a foreign object, stop the engine and
disconnect the spark plug wire(s). Thoroughly
inspect the machine for any damage. Repair the
damage before restarting and operating.
1.
If the blades are ENGAGED (ON), place the
PTO in the DISENGAGED (OFF) position.
2.
Place the throttle near the SLOW
position.
3.
Engage the parking brake.
Turn Key Start: Turn the ignition
key counterclockwise to the STOP
position.
Push Button Start: Press or
remove the ignition key.
5
7

Capítulos

Tabla de contenido

Solución de problemas

loading

Tabla de contenido