Emergency Opening - BTV GUARDIAN Manual De Instrucciones

Pairing remote controls
All remote controls are factory paired.
CANCEL ALL THE REMOTE CONTROLS:
This option will make all remote controls unusable.
Main buttons: Press and hold the ST-2 button. You will hear a beep. Keep pressing
for about 8 seconds, until two more beeps sound. All the main buttons on the
controls will be canceled.
Reinforcement buttons: Press and hold the ST-1 button. You will hear a beep.
Continue to hold for about 15 seconds until two more beeps sound. All the
reinforcement drive buttons of the controls will be canceled.
ADD A REMOTE CONTROL:
Main buttons: Press the ST-2 button and release. You will hear a beep. Then press
the ST-2 buttons and the button
main buttons on the remote will be added.
Reinforcement buttons: Press the ST-1 button and release. You will hear a beep.
Then press the ST-1 buttons and the reinforcement button together. You will then
hear three beeps. Reinforcement buttons will be added.

Emergency opening

If all the controls are lost or the lock can not be opened with the controls, there is
an emergency opening mode.
When installing the lock, note the place where the emergency opening point is
located.
In case of needing to use the emergency opening, a hole of 3 to 4 mm must be
drilled in the door where the emergency opening is located. Once the drill is done,
use a screwdriver to turn the screw and open the lock.
together. You will then hear three beeps. The
ST-1
ST-2
Emergency
opening
EN
7