Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Part 1A – Mounting to the Wall (Drywall)
IMPORTANT! For safety reasons, this mount must be secured to at least two wood
studs no less than 16" apart. The studs must be capable of supporting the combined
weight of the mount and display.
Use a high quality stud finder to locate two adjacent studs where you wish to install your
mount. Mark both edges of each stud to help identify the exact center.
NOTE: You must use the center of each stud to avoid cracking or splitting the wood
during installation.
Place the mount against the wall over the marked studs. Make sure it is level.
While another person holds the mount in position, mark four locations (two per stud) for
securing the mount to the wall (see Fig. 1).
Set the mount aside and drill a 6 mm (1/4") pilot hole at each marked location.
Place the mount back against the wall and attach it using four of the lag bolts (A) and
M9.5 x 22 x 2.5 washers (B) provided (see Fig. 2). Do not over-tighten these bolts and
do not release the mount until all bolts are in place. Ensure that the mount remains level
after all bolts are secured.
13
Tabla de contenido
