Tabla de contenido
Idiomas disponibles
Idiomas disponibles
How To Install The Speed Control
Rod
1. Put the speed select lever to the
NEUTRAL position.
2. Attach the ball joint, located on the
bottom end of the speed control rod,
to the shift yoke assembly. See
Figure 9. The fasteners
are attached
to the ball joint at the factory.
3. The length ot the ball joint and speed
control rod have been pre-adjusted
at the factory. If an adjustment is re-
quired, loosen the nut. Remove the
fasteners
to disconnect the ball joint
from the shift yoke assembly.
To
lengthen or shorten the speed con-
trol rod, turn the adapter to obtain
the correct length.
4. Make sure the speed select lever
functions correctly. Move the speed
select lever through all speeds.
Speed Select
Figure 8
Assembly
Ball Joint
Fasteners
Figure 9
How To Assemble
The Chute Deflector
1. Remove the carriage bolt. See
side of the flange.
Figure 10.
4. Fasten with washer and Iocknut.
2. Raise the chute deflector into oper-
ating position.
5. Tighten Iocknut securely.
3. Fasten chute deflector to flange with
NOTE: Make sure all carriage bolts
carriage bolt. Make sure to install
in flange are tight. DO NOT OVER-
with head of carriage bolt on the in-
TIGHTEN.
J_
Figure 10
F-031068L
10
Tabla de contenido
