Idiomas disponibles
Idiomas disponibles
blender attachment, you can order it from
our accessory range by quoting article no.
ZB 9045.
Operation
- Always use a suitable container for
operation. A tall container with a flat
bottom is best.
- Push the slide cover upwards and insert
the blender attachment.
- Push the blender down into the
ingredients in the bowl before switching
the unit on. Start with a low speed
setting.
●
On some models, the blender attachment
may be made of plastic. Such
attachments must not be immersed in
very hot water.
- Make sure that the unit can rotate freely
inside the bowl and is not blocked during
operation.
- After switching off, always wait until the
motor has come to a complete standstill
before lifting the blender from the
mixture.
- Always remove the plug from the wall
socket after use.
Hand mixer models with additional chopper
attachment
When ordering the chopper attachment,
please quote article no. ZB 9046.
Operation
- Fit the cutting blade unit into the bowl
before filling the bowl with the food to be
chopped. Exercise extreme caution: the
blades are very sharp. When handling the
blades, always hold them by the upper
protective plastic covering.
- Position the lid securely on the bowl.
- Push the slide cover upwards and fit the
hand mixer to the lid of the bowl.
- Insert the plug into the wall socket and
operate the switch in brief bursts until the
mixture has reached the desired
consistency. During processing, the lid
and bowl should be securely held in
place.
- Avoid overfilling the bowl. It may be
filled with herbs etc. up to half. Before
the bowl is filled, the food to be
processed should be cut into pieces of
about 1 cm.
- Do not fill the bowl with hot liquid or
hard material such as ice cubes, nutmegs,
hard grain, coffee beans, rice or spices.
Other food such as chocolate or raw
meat are also unsuitable for processing.
- After processing, always remove the plug
from the wall socket before removing the
lid and detaching the hand mixer by
pressing the release button. The
processed food and the blade unit can
now be taken out.
- When processing further food after the
first cycle, make sure that the receptacle
for the blade unit at the bottom of the
bowl is free of food residue before
refitting the unit.
General cleaning and care
●
Before cleaning the appliance, ensure it is
disconnected from the power supply and
has cooled down completely.
●
To avoid the risk of electric shock, do not
clean the appliance with water and do
not immerse it in water.
●
Do not use abrasives or harsh cleaning
solutions for cleaning.
- The housing may be wiped with a slightly
damp, lint-free cloth.
- The beaters and dough hooks may be
cleaned using hot water and a mild
detergent.
- The blade unit of the blender attachment
can be unscrewed for cleaning. Before
removing it, ensure that the drive pin on
the shaft sits correctly in the
corresponding recess on the blade unit.
The unit may be cleaned with a suitable
brush. Caution: the blades are extremely
sharp. To replace the unit, hold it in a
suitable cloth and screw it back on in a
clockwise direction.
- The lid of the chopper attachment can be
10
