Nikken PIMAG WATERFALL Manual De Uso página 5

System and installation must comply with state and local regulations.
Prior to assembly, compare the main diagram with your PiMag Waterfall
Gravity Water System, and make sure all the components are present.
1. Wash the inside of the water fill tank (E), the supply tank cover (F) and the
inside of the water supply tank (G) with water and a mild detergent or soap.
IMPORTANT: Do not use a scrubber sponge or dry with paper towels. Rinse
both tanks very thoroughly. Do not wet the battery compartment when
washing.
• Place the supply tank on the base (H).
• Remove mineral stones from package, rinse thoroughly and place
inside the supply tank.
IMPORTANT: Do not put mineral stones in the circular recess located in the
center of the supply tank. This space is required for inserting the filter column.
The water tap (I) is provided fully assembled and attached to the tank.
2. Place the supply tank cover (F) on the water supply tank (G).
• Place water fill tank (E) on top of this cover.
3. Remove packaging from filter assembly (B, C, D). Pull off the top cap (B) of
filter assembly and set aside. Remove all prefilter pads (C).
4. Place the filter cartridge upright in an empty pot or pail, with the top of the
cartridge upward. Slowly fill the pail with cold water.
IMPORTANT: Do not use hot water. Do not use soap or detergent to clean the
cartridge.
ASSEMBLY INSTRUCTIONS
• Continue filling until the level of the water is just below the top of the
cartridge. Do not overfill. Do not allow the water level to cover the top of
the filter cartridge.
• Place the five prefilter pads inside the pail. Allow all the pads and the
cylinder to soak at least 8 hours. If the level of water in the pail drops,
refill as necessary. For best results, exercise care to avoid submerging
the top of the filter cartridge.
5. After soaking is complete, reassemble the filter cartridge, prefilter pads
and top cap. Install the assembled filter in the Waterfall unit.
6. Remove the cover (A) from the top of the Waterfall tank and fill the unit with
cold water. Pull outward on the water tap lever to lift until it locks in the
open position, for draining.
• Fill and drain the unit while the tap is open, for two full cycles.
5
®