Deleting Groups (The New 100 Series Only); Transferring Group Prog. To Several Intercom Microphone Bases (New 100 Series Only) - EIS 400 Serie Manual De Uso E Instalación

EIS

3.1.6. Deleting Groups (the New 100 Series only)

To delete a group, key 922
9
followed by pressing the PRG
button.
Use the INC and DEC buttons to
move between all the groups
defined to date. To delete them
all, select the ALL option. To
delete just one, select that group
(for example, group #9).
Press the PRG button.
Use the INC and DEC buttons to
move between confirming (ON)
or canceling (OFF) the
operation to delete. If you are
certain you wish to delete this
group, select the ON option
while pressing the PRG button
for 1 second.
2 2
PRG PRG
1
4
PRG
1
on
4
PRG
1s
3. User Manual
3.1. To make an announcement
3.1.7. Transferring Group Programming to
several Intercom Microphone Bases
(the New 100 Series only)
In New 100 Series installations with zone extension (see 2.1.2.)
where several microphone bases coexist, group programming may
be transferred from one base to another, thus avoiding the need to
repeat the process of programming the groups into each
microphone base.
To proceed, make sure the groups have been previously
programmed (see 3.1.5.) into any one of the microphone bases.
At that microphone
9 3
base, key in option
932 followed by
pressing the PRG
button. The base then
goes into SEND mode
for 1 minute.
Next, activate RECEIVE
mode by keying in 931
9 3
followed by pressing the
PRG button.
When the receipt of data is complete, the number of groups received
is indicated unless the legend ERROR appears, indicating that the the
process has not been completed satisfactorily.
16
ENG
2
PRG PRG
1
PRG PRG