Idiomas disponibles
Idiomas disponibles
GB
7.7
TO STOP THE ENGINE
1.
Disengage power to the cutting units with
the cutting unit switch.
2.
Remove foot from the FWD/REV pedal.
3.
Set the parking brake.
3.
Move the throttle control lever to the SLOW
position.
4.
Turn the ignition key to OFF.
7.8
PUSHING THE MACHINE WITH THE
ENGINE STOPPED
1. To push, disengage the parking brake.
2. Turn screw (A) located on the underside of the
transmission pump 1 turn counterclockwise.
Set the steering wheel so that the rear wheels
are pointing straight ahead.
3. Remove the tower cover and turn the
emergengy brake valve( B) towards the parking
brake/hour meter side of the tower.
4. Turn the steering wheel to the left until resis-
tance can be detected. The machine is now
ready to push. If unable to move the machine
apply further pressure to the steering wheel.
Excessive force should never be used on
the steering wheel.If the rear wheels start to
turn too much force is being applied.
5. After pushing, return valve (B) and knob (A) to
their previous positions.
GB-22
RANSOMES HIGHWAY 2130
SAFETY AND OPERATORS MANUAL
