Masko M-SP-3248 Manual De Instrucciones página 12

Idiomas disponibles
  • ES

Idiomas disponibles

Storage:
Jump starter Should be stored in a dry, well – ventilated place out of the reach of children. Do
not store in locations where temperature may exceed 45° C or lower than -10°C. protect the
unit from direct sunlight, heat, and moisture.
Warnings:
Always check that the battery clamps are connected in the correct polarity RED Clamp
to positive (+) terminal, Black Clamp to the negative (-) terminal.
DO NOT Connect the Jump start clamp to the vehicle battery in reverse polarity after
pressing the 'BOOST' key on the intelligent Jumper cable, this can damage the vehicle
and the Jump start.
DO NOT touch the two Jump start clamps together after pressing the 'Boost' Key on the
intelligent Jumper cable, this can damage the Jump start.
Remove the Jump Start clamps form the vehicle battery within 30 seconds after Jump
starting the vehicle.
DO NOT attempt to Jump start a vehicle more than 3 times. If this does not work, there
are other problems with the Vehicle.
DO NOT operate the appliance in explosive atmospheres, such as in the presence of
flammable liquids, Gases, or dust.
Charge only at ambient temperature between -20° C - 60° C.
Charge only using the charger provided with MASKO 3000A Jump starter.
DO NOT modify and disassemble MASKO 3000A Jump starter.
DO NOT immerse the device in water or allow it to become wet.
Under extreme Conditions, Battery leakage may occur. Carefully wipe the liquid off
using a cloth and avoid skin contact. In case of skin or eye contact, rinse immediately
with clean Water and seek medical attention.
At the end of its usable life, discard the appliance with due care for our environment.
Hergestellt für Dilaw Warehouse GmbH // Fuggerstraße 15a // 48165 Münster // Germany
12
www.eshopping.de
loading