Idiomas disponibles
Idiomas disponibles
POSITEC Inc. has established a partnership with
the RBRC Corporation to recycle any Positec
batteries with the RBRC-call2recycle seal. For
environmental protection, please do not discard
batteries in the trash. After the batteries' life cycle
is ended, then please call 1-800-822-8837 for
a free service that will properly dispose of the
battery.
ASSEMBLY & OPERATION
NOTE: Before using the tool, read the
instruction book carefully.
BEFORE OPERATION:
Assembling and disassembling the Power
head attachment. (See Fig. A1, A2, A3)
1. Remove the protective cap from the end of the
attachment shaft.
2. To assemble, align the triangle icon on the button
with the arrow label on the attachment shaft.
EN
3. Push the shafts together until you hear a "click".
The edge of the arrow label should be close
to the shaft connection housing.(Note: If the
straight edger head cannot be fully installed into
the power head, rotate the blade a little until it is
possible to insert the shaft fully.)
4. Finish the assembly by tightening the knob
clockwise.
5. To disassemble, loosen the knob, turn counter
clockwise, then press the release button and
pull the shafts apart. Replace the protective cap
on the attachment shaft to ensure that dust and
debris do not get into the shaft.
A1
6
A2
2
A3
3
2
Adjust the cutting height (See Fig. B1, B2)
1. Turn off the power tool and remove the battery.
2. Loosen the wing nut. Push the wheel upwards to
increase the cut depth (a) or downward the wheel
to reduce the cut depth (a).
3. It is recommended to adjust the depth wheel so
that the edger blade just touching the ground or
breaks the surface of the soil by no more than 0.2
in. (5 mm)
4. Tighten the wing nut. Check the depth of cut
while standing in the normal working position and
correct it if necessary.
B1
3
1
1
2
1
