Idiomas disponibles
Idiomas disponibles
3 • Setting the temperature
Set the iron temperature to suit the type of material using the temperature control dial
(fig.3).
Temperature control*: The temperature control light indicates that the soleplate is
heating up. When the temperature control light goes off (fig.10), the set temperature is
reached and you can begin ironing.
Ironing label
IMPORTANT The iron takes longer to cool down than to heat up.
We recommend that you start with fabrics to be ironed at a low temperature.
For mixed fabrics set the temperature for the most delicate fabric.
TIP Always spray starch onto the reverse side of the fabric to be ironed.
4 • Dry ironing
Set the variable steam control to
material (care points •, ••, •••).
5 • Steam ironing
You can steam iron from temperature setting •• upwards.
Steam function :
The steam quantity can be set to between no steam (minimum steam
quantity) and
(maximum steam quantity) (fig.12).
We recommend setting to maximum steam quantity
setting •••.
6 • Shot of steam
(from temperature setting •• upwards)
Press the shot of steam button
Wait a few seconds between each shot before pressing the button again.
7 • Vertical shot of steam
(from temperature setting •• upwards)
TIP Hold the iron 10 to 20 centimetres away from the garment to avoid burning
delicate fabrics.
Hold the iron to the vertical and press the shot of steam button (
creases from suits, jackets, skirts, hanging curtains etc.
IMPORTANT Never direct the steam at persons or animals!
8 • Spray
Press the spray button
9 • Anti-Drip system
This prevents water escaping from the soleplate when the temperature is too low.
10 • Automatic electronic 3-position cut-out*
If, although switched on, the appliance is not moved, it will automatically switch off and
the auto off light will blink after the following intervals:
- After 30 sec., if the iron is left resting on the the soleplate or lying on its side.
- After 8 mins., if the iron is left resting on its heel.
To switch the iron back on, move the iron gently.
AFTER USE
11 • Emptying
Unplug the iron (fig.4), pour away remaining water (fig.16) and set steam control to
Open and close the steam control several times (fig.17) to prevent the valve hole into the
steam chamber from scaling or blocking up.
12 • Storing
Allow the appliance to cool down before storing the iron standing on its heel (fig.23).
* depending on model
Fabric
Synthetic fibres, e.g.
viscose, polyester...
Silk, wool
Cotton, linen
(fig.11) and set the temperature to suit the type of
to generate a powerful jet of steam (fig.13).
to dampen stubborn creases (fig.15).
3
Temperature
control
•
••
•••
only when the iron is at temperature
fig.14) to remove
EN
NL
DE
FR
IT
ES
PT
EL
TR
DA
SV
FI
NO
.
AR
