Idiomas disponibles
Idiomas disponibles
1. The Failure led turns off.
2. The pressure switch activates the pump.
3. The Pump ON LED will illuminate while the pump
is running
4.3. CHECK POINTS AFTER START-UP
Compruebe que, tras abrir las llaves del circuito, al
funcionar el presostato el ruido de la máquina es
normal, que no vibra y que el caudal y presión del
agua es adecuado.
Check that, after opening the circuit taps, the machine
noise is normal when the pressure switch operates,
that it does not vibrate and that the water flow and
pressure are adequate.
If you detect any anomaly in the machine, stop
immediately, disconnect it, check the installation
and power connections. In case of any anomaly or
problem, take the machine to technical service for
repair. Under no circumstances continue using the
machine if its operation does not seem adequate.
5. MANTENIMIENTO Y SERVICIO
When it is necessary to disconnect the pressure
switch from the water network (e.g. for cleaning,
maintenance or storage), proceed as follows:
Disconnect the pressure switch from the power supply
by removing the power plug from the outlet.
1. Next, disconnect the power supply to the
pressure switch pump.
2. Open a water tap connected to the pressure
switch to release any remaining water pressure.
3. Loosen the pressure switch water outlet
connection and then the pressure switch water
inlet connection.
4. Empty the pressure switch (and also the pump).
Carefully dry the pressure switch and power
cable.
17/84
English
