Idiomas disponibles
Idiomas disponibles
CAUTION:
The appliance can not stand upright on its own. If you
are not using the wall mount, gently place the vacuum
cleaner on the floor.
• This rechargeable battery vacuum cleaner is no
adequate replacement for a conventional floor vacuum
cleaner. Especially on shag-pile carpet, the cleaning
performance is not sufficient owing to its design.
• Contaminated filters reduce the suction power of the vac-
uum cleaner. Therefore, we recommend regular cleaning
of the existing dirt filters.
• Ideally, clean the filters whenever they have been subject
to a prolonged use.
• Please regularly check and clean the electric floor
nozzle.
• If necessary, clean heavily soiled floors multiple times
and / or use a conventional 230 V~ floor vacuum cleaner.
Switching the Appliance On / Off
• The button (5) turns the appliance on and off. Only press
the button briefly. You do not have to press and hold the
button.
• The appliance starts at high power level.
• Press the ECO button to toggle between low and high
power levels. In ECO mode, you can extend the life cycle
of the rechargeable battery.
Start-Up
Suction Pipe
• Insert the suction pipe with the two contact pins into
the connection on the hand appliance. It must audibly
engage.
• To disconnect the suction pipe, press the release (8) and
pull out the pipe at the same time.
• Use the bracket to attach the upholstery / brush nozzle
and the crevice nozzle to the suction tube. This way, you
always have the accessories at hand.
Floor Nozzle with Turbo Brush
• The floor nozzle is suitable for all floor coverings except
for shag-pile carpets.
• During operation, the LEDs on the floor nozzle light up
for better visibility in dark areas.
CAUTION:
You cannot replace the LEDs.
• Stick the lower end of the suction pipe onto the connec-
tor on the floor nozzle. Note the contact pins on the floor
nozzle. The suction pipe must audibly s snap into place.
• To disconnect the suction pipe, press the release (13)
and pull out the pipe at the same time.
52
PC-BS3085A_IM_new
Flexible Suction Hose
Thanks to this expandable suction hose, you will be able to
reach any hard-to-reach area.
• Insert the end of the suction hose, where the release is
located, into the connection on the handset. Note the
recess for the release on the handset. The connection
must audibly engage.
• In order to disconnect the suction hose, press the re-
lease on the suction hose and pull it off simultaneously.
Nozzle Attachments
There are three different ways to connect these nozzles to
the appliance:
Connection at the Hand Unit
• Plug one of the nozzles into the port on the handset.
Note the recess for the release on the handset. The
connection must audibly engage.
• In order to release the respective nozzle, press the
release (10 or 11) while simultaneously pulling it off.
Connection to the Suction Pipe
At the lower end of the suction pipe, you will find the same
plug connection as on the handset. Mount / dismount the
nozzle as described above.
Connection to the Flexible Suction Hose
• Note the recess with the guide lug on the connection of
the suction hose.
• Take one nozzle and plug it onto the suction hose. The
connection must audibly engage.
• In order to release the respective nozzle, press the
release (10 or 11) while simultaneously pulling it off.
Crevice Nozzle
For vacuuming dirt from corners, joints and small gaps.
Combined Upholstery / Brush Nozzle
This nozzle is suitable for removing dust from smaller
surfaces such as upholstery, furniture or curtains. Use
the nozzle with locked brush to prevent scratching of the
surface to be cleaned.
• For this, press the button and push the brush to the end
of the nozzle. It must engage.
• Press the button again to unlock the brush.
Assembly the Wall Holder
WARNING:
Make sure beforehand whether there are cables in the
wall which could be damaged!
CAUTION:
Place the wall holder so that the appliance is not exposed
to direct sunlight or other heat sources.
07.07.21
