Idiomas disponibles
Idiomas disponibles
Fig. 4
Chain/sprocket end cover
3. Remove the cutting bar and chain from the mounting surface
(Fig. 5).
Fig. 5
Chain
4. Remove the old chain from the bar.
5. Lay out the new saw chain in a loop and straighten any
kinks. THE SHARP SIDE OF THE TEETH MUST FACE AWAY
FROM YOU IN THE DIRECTION OF THE CHAIN ROTATION
INDICATED ON THE GUIDE BAR
. If the teeth face backwards, turn the loop over (Fig. 6).
Fig. 6
Sharp cutting edge
Chain drive link
6. Starting at the tip, mount the chain drive links into the
bar groove, leaving a loop at the back of the bar. The chain
will loosely fit until it is placed on the sprocket
(Figs. 7 & 8).
NOTE: Make certain of the direction of the chain
backwards, the saw will vibrate abnormally and will not cut.
Fig. 7
Fig. 8
Cutting bar
7. Hold the chain in position on the bar and place the loop
around the sprocket. Fit the bar flush against the mounting
surface so that the bar studs are in the long slot of the bar
and the adjusting pin is in the chain tension pin hole
(Fig. 9).
Fig. 9
Chain rotation
8
.If the chain is mounted
Loop
Sprocket
Chain tension pin hole
(with adjusting pin)
Bar studs
R
