Idiomas disponibles
Idiomas disponibles
Insert mains plug of the battery charger into a mains power socket:
Red and green LEDs are lit.
Connect the battery (1) to the battery charger (2):
Charging control lamp (3) flashes green: Battery is being charged.
Charging control lamp (3) is lit green: Battery is fully charged. (For charging time, see Technical Data).
Keep button pressed and remove the battery.
Disconnect mains power plug from the mains power socket.
Storage:
The place of storage must be inaccessible for children.
Keep button pressed and remove the battery.
Disconnect mains power plug from the mains power socket.
Store battery charger in a dry, frost-proof place.
Store the battery only in a charged state! Fully recharge the battery after 12 months of storage, at the latest!
Troubleshooting:
Before eliminating faults, disconnect the mains power plug!
• Fault lamp (4) is lit red: Battery temperature is outside the permissible charging temperature (5°C to 45°C).
• Fault lamp (4) flashes red: Battery is defective.
If the battery temperature is between 5°C and 45°C and the red fault lamp (4) is nevertheless lit,
there may be a faulty contact.
• Clean contact points on battery.
In the event of other faults, please contact Valsir's customers service.
4. Care and Maintenance
Remove the battery prior to carrying out any work on the machine.
Check that the expander heads are fully functional. Damaged expander heads must not be used.
Periodically have the guidance inclusive thread checked referring to damages. Clean and grease the expanding pin when you have finished work.
If the seal is damaged the warranty will be null and void. After 20,000 expanding cycles or 2 years have the machine serviced. For themaintenace and
repair please contact the Valsir's customers service.
When dispatching the machine ensure that it is packed in its carrying case completely with battery and charger in the carrying case only.
Electro-hydraulic machine does not exceed 3 hours in a -5° C storage. Disconnect battery from machine before storing.
If oil leaks, please contact Valsir's customers service.
Charger:
If the supply cord of this appliance is damaged, it must be replaced.
5. Disposal
Components of the unit are in recyclable material and should be put to recycling. For an environmentalfriendly disposal of the non-recyclable parts
(e.g. electronic waste) please contact your local waste disposal authority. Old batteries must not be littered in fire or in domestic waste.
For EU countries only:
Do not dispose of electric tools with domestic waste. In accordance with European Directive 2012/19/EC on waste of electrical and
electronic equipment and its implementation as national law, electric tools that are no longer serviceable must be collected separately
and utilised for environmentally compatible recycling.
18
