Idiomas disponibles
Idiomas disponibles
Preparations
Parts of the seat
1.
Adjustable Headrest
2.
Should Belt Guide
3.
Booster
4.
ISOFIX Locking Arms Release Handle
5.
Lap Belt Guide
Installation of the seat
When installing the booster seat in the
—
front vehicle seat make sure the backrest
of the
vehicle s e a t
Position the seat inside the vehicle.
—
Pull the ISOFIX locking arms release
—
handle to release the ISOFIX connectors.
Click the ISOFIX connectors to the
—
ISOFIX anchorage points in the vehicle
seat.
Make
sure
indicators are GREEN.
Push the booster seat as far as possible
—
towards the backrest of the vehicle seat.
Make sure the back of the booster is
—
touching the backrest of the vehicle seat.
If
the
seat
—
combination
with
points in the vehicle seat, the ISOFIX
connectors can be stowed inside the
booster seat and the booster can be
in
combination with
Adjusting the headrest
The Adjustable Headrest (1) can be
adjusted by using the Headrest Height
Adjuster (7) at the back of the headrest (1).
Adjust the headrest so that max. 2 cm
(approx. 2 finger's width) remain between
the child's shoulder and the headrest.
Positioning of the child
Sliding the shoulder belt
—
shoulder belt guide.
Child sitting into the booster seat.
—
Position the vehicle belt in front of the
—
child and locking the belt into the
buckle of the vehicle.
Adjusting the headrest to fit the
—
shoulder height of child.
Tightening shoulder belt and make sure
—
the belt is not twisted.
is in an upright
position
that
all
ISOFIX
cannot
be
used
ISOFIX
anchorage
the 3-point belt
only
in the
6.
Backrest
7.
Headrest Height Adjuster
8.
ISOFIX Locking Arms
9.
ISOFIX Release Buttons
10. Instruction manual Storage Area
Removing the seat
Perform the installation steps in reverse
order.
Remove the shoulder belt out of the
—
shoulder belt guide by sliding the belt
out.
Release both ISOFIX connectors, by
—
pulling the ISOFIX release handle.
Remove the seat from the vehicle and
—
push the ISOFIX Locking Arms fully
back into the transport position.
Removing and re-attaching the seat
cover
in
The cover of the car seat consists of three
parts (headrest, backrest, booster). These
are held in position at several places by
used
press studs and elastic bands.
.
Once all attachments have been released,
the single parts of the cover can be removed.
In order to put the covers back on the seat,
follow the removal instructions in the reverse
order.
Care and maintenance
Do
not
—
gasoline or other organic solvent to wash
the car seat. It may cause damage to the
car seat.
Please remove the car seat from the
—
vehicle seat if not in use. Store the s eat
in a cool, dry place where your child
cannot access it.
For seat cover washing instructions, see
—
the wash label at the inside of the fabric
cover.
use
undiluted
detergents,
