Idiomas disponibles
Idiomas disponibles
MOUNTING LOCATION
Before you start the installation, it will be necessary to find a mounting location for the
HBD-10V. Find a location in which the HBD-10V will receive adequate ventilation in order to
dissipate the heat it develops during operation. Two popular mounting locations are in the
trunk or under the seat.
Setect the location in which you wish to mount the HBD-10V. Use caution when mounting the
HBD-10V. There are many wires, gas lints, vacuum lines, brake lines as well as a gas tank in
the automobile, Make sure you know where they are when mounting the HBD-10V to avoid
puncturing lines, shorting wires or drilling holes in the gas tank. Once you are ready, use a
pencil to mark the mounting holes in the bottom panel. After you have marked the locations of
the holes move the HBD-10V out of the way and drill small starter holes to make the tapping
screws easier to install. Use provided screws to tighten down the HBD-10V.
REMOTE CONTROL MODULE
Before connecting the remote, it will be necessary to find a mounting location that will be
easy to access for adjustment. Once you select your mounting location, you will need to run
the control wire from the remote to the HBD-10V. To avoid possibility of induced noise from
the car's electrical system(i.e., popping noises or engine noise), run the cable from the
remote to the HBD-10V away from the car's electrical wiring.
REMOTE
FUSE
03
12V
REM GND
3
