Idiomas disponibles
Idiomas disponibles
RESIDUAL DANGERS
Warning – electrical voltage
Before carrying out any work on the appliance, remove the mains plug from the mains socket!
Unplug the power cord from the mains socket by grasping the mains plug.
Warning
Dangers can arise from this appliance if it is used improperly or for an unintended purpose by
untrained individuals! Observe the staff qualifications!
Warning
The appliance is not a toy and should not be handled by children.
INTENDED USE
This charger has been designed to charge lead-acid batteries in cars. It is therefore suitable for
almost all common batteries. Any other use is not permitted. In particular, it is not suitable for
charging NiCd or NiMH batteries or any other non-rechargeable dry batteries. Not for continuous
operation Use the product only for the purpose it is intended for. The manufacturer accepts no
liability for damage caused by improper use. Any modification to the product may negatively
impact safety, cause hazards and invalidate the warranty.
Only suitable for domestic use; not for commercial use.
UNPACKING INSTRUCTIONS
Open the box and remove the product.
After unpacking, please check the product for damage and to ensure it is complete. Subsequent
claims cannot be accepted.
COMMISSIONING
We recommend disconnecting the battery from the vehicle before you charge it. This prevents
potential damage. To prevent the loss of security systems and e.g. audio system memories, you
can install an additional appliance. The mains plug must NOT yet be connected when you connect
the terminals to the battery. Open the bonnet and remove the battery cover. We also recommend
disconnecting the on-board power supply. First disconnect the negative pole (-), then the positive
pole (+).
Connect the charger to the battery. First connect the positive pole to the red terminal, then the
negative pole to the black one. If these connections are secure, then you can proceed with step
2.
Connect the charger to the socket. The mains light indicates that the mains cable has been
connected to the socket. The error light indicates that the battery terminals have been connected
incorrectly. The reverse polarity protection ensures that the battery and the charger do not get
damaged. The lights indicate the charging progress. The status of the battery charge can be
monitored on the LED display. These lights go out one after the other. If only MAX/100% / FULL
lights up on the display, this indicates that the battery is charged. Once charging is complete, flip
the switch and disconnect the power supply before you remove the charger.
10
www.DEUBAXXL.de
