Rocktrail 2.1 Guía Rápida página 13

Taking care that the release of tension does not
cause any injury.
Remove the rubber band and throw the product
away from you into the air.
Set up the tent with guy lines
(see Fig. H).
Dismantling the tent
Please watch the tent dismantling information
video by using the QR-code with a suitable
appliance.
Grasp the centre of the upper hoops in one
hand and pull the centre points of the lower
hoops up to them. Start at the rear end of the
tent so that the air can escape completely
through the front entrance (see Fig. A–B).
Hold the tent upright and hold all 4 hoops in
one hand (see Fig. C).
Push the top of the upper arch towards the
ground and roll into the middle. Push the new
hoops down with one hand while the other
hand continues to hold the 4 hoops together
(see Fig. D–E).
New hoops will form as you continue to push
down. Loosen the grip of the hand holding the
4 hoops together and slide all the arches into
each other (see Fig. F).
Arrange all the arches on top of each other
and secure them with the rubber band (see
Fig. G). You can now pack the tent in its bag.
Cleaning and care
CAUTION! Never wash the tent in a washing
machine. Otherwise the product may lose some
of its ability to keep out water.
CAUTION! Never use petrol, solvent or other
cleaning agents. Otherwise there is a danger
of damage to the product.
Condensation can form in all synthetic tents; you
should therefore air the tent as frequently as possible
in order to counteract this.
and pegs
2 3
For cleaning the tent and removing any stains
you should only use a cleaning agent that is
specifically intended for cleaning polyester tents.
Remove any dirt from the tent
sponge and clean water.
Please allow all parts to dry thoroughly before
you repack the tent . This will prevent the for-
1
mation of mould, bad odours and discolouration.
If the zipper sticks when being opened or closed,
spray it with silicone spray.
with a soft
1
GB/IE 13