Idiomas disponibles
Idiomas disponibles
B
Product usage
Assembly
1.
Turn the heater upside down and place it on a protected surface to avoid scratching it.
2.
Remove the 2 screws from the underside of the heater.
3.
Align the hole on the feet with the screw holes on the heater. The open edge of the feet
should be facing outwards. Insert the screws and tighten them until they are securely
fastened in place.
4.
Turn the heater upright.
Before using the product
WARNING!
•
Correctly connect the unit and do not leave it within the reach of unsupervised
children.
•
It is normal for heaters to emit an odour and smoke when they are turned on
for the first time or have not been used for a certain period of time. This will
disappear after a short while.
•
The heater must always be placed in an upright position on a horizontal surface.
If the heater tips over, turn it upright immediately.
•
Place the heater on a stable, heat-resistant and non-combustible horizontal surface
that is at least 30 cm (sides and rear) and 50 cm (front) clear of objects such as walls,
furniture and curtains.
•
Never place the heater below electrical sockets.
•
The heater is suitable for use in a 10-15 m² space, such as a living room or office.
•
Do not use the heater in a bathroom or near to a swimming pool or other body of water.
The heater must never become wet. Do not use the heater in wet or humid conditions.
•
Make sure the air inlets are unobstructed. Do not cover the heater's air inlet or outlet
vents/grilles.
Operation
1.
Fully unwind the power cable.
2.
Check the heater's rating plate for the correct voltage. Make sure the temperature dial
is in the MIN position and the power dial is set to the off position (0). Connect the plug to
a mains socket with a suitable voltage.
Turn the temperature dial clockwise towards the MAX mark until you hear a clicking sound
3.
and the heater starts to work. Turn the temperature dial up to increase the temperature.
4.
Turn the power dial to select the power level: I (low), II (medium) or III (high).
5.
Turn the temperature dial anticlockwise towards the MIN mark to decrease the heater
temperature.
15
EN
