Tabla de contenido
Idiomas disponibles
Idiomas disponibles
8.8 PM-8Z / PM-32Z Connection
- Connect to the PM-8Z / PM-32Z to the rear side of MX-88 using a CAT5 UTP cable. Same
connection method of WP-8A.
- Maximum distance from MX-88 to PM-32Z is 300 m.
- Immediate broadcasting is allowed without separate ID setting.
- 4 PM-8Z / PM-32Z can be connected per MX-88.
- Flashing of buttons mean defect of the unit or connection status, thus check connection status and
the unit.
8.9 PM-8Z / PM-32Z MIC Broadcasting
- Connect a MIC to the MIC input jack. Both dynamic MIC and condenser MIC can be used.
- Press the button of the corresponding zone to be broadcasted, button will light on. All zones of
MX-88, are selected when pressing the ALL button.
- R is displayed on the input selection displays of broadcasting zones.
- Press the CHIME button, PM-8Z / PM-32Z begins to broadcast the CHIME signal to selected
zones.
- Press and hold the TALK button to start broadcasting.
- Release the button to end broadcasting.
8.10 PM-8Z / PM-32Z Priority and busy
- Broadcasting of any PM-8Z / PM-32Z is allowed in non-broadcasting zones.
- If any zone button turns on and BUSY LED is lighting, it means that other unit is already
broadcasting in the same zone.
8.11 PM-8Z / PM-32Z Groups of zones
The unit allows to create groups of zones. To assign zones to a group press for 2 seconds the
group key to edit, it will flash indicating that the system has entered in edition mode, and select the
desired zones. Press the group key for 2 seconds again to finish and save the configuration in
memory. If you press for less than 2 seconds configuration is only stored temporally and it will be
lost if system is restarted.
8.12 PM-8Z / PM-32Z Zone lock
Select the zones and press the CHIME key for 2 seconds to block them. From then on, no other
zone keys can be selected or deselected. Press again for 2 seconds or restart the device to release
the zones.
MX-88 Version 1.0
MX-88
AUDIO MATRIX 8x8
Page 13 of 18
Capítulos
Tabla de contenido
