How It Works - Orbegozo SC 4600 Manual De Instrucciones

SC 4600
• The Spin-dryer will not start accidentally because to start working, the lid must be kept shut with
one hand and, with the other hand the small lever must be turned clockwise while exerting a little
pressure.
• The lid cannot be opened while the Spin-dryer is working, since it is locked from the inside.
• If the brake should break while the drum is spinning, the lid will become jammed.
• If the command cable snaps, the Spin-dryer does not start.

HOW IT WORKS

The ORBEGOZO Spin-dryer works based upon the principle of centrifugal force, which originates in
the drying drum a few seconds after you start it. This force, which increases gradually as the drum
accelerates (up to 2,800 rpm), makes the wash/rinse water that is still contained in the clothes drain
through the holes in the drum. This way clothes are gently pressed against the wall of the drum
without any damage to them and they come out in a few minutes with the ideal humidity for ironing.
STARTING THE SPIN-DRYER
Before using the Spin-dryer for the first time, remove everything from the inside and clean the
stainless steel drum with a damp cloth.
1) Before connecting the plug of the Spin-dryer to the A.C. outlet, turn the command lever counter-
clockwise to the "O" position (Fig. A). The lid will open by itself.
2) Place wet clothes inside the drum, distributing and pressing them softly and evenly, especially if
you do not fill the drum completely. Place heavier clothes (jeans, towels, etc.) at the bottom in a
circular manner against the walls of the Spin-dryer, filling the empty space in the middle with other
clothes. So that it works better, we recommend using it always with the drum almost full, leaving a
couple of centimetres free from the top rim.
3) IMPORTANT: Regardless of the amount of clothes you have put in, cover clothes with a cloth,
towel or napkin, pushing down the edges between the drum and the clothes (Fig. B). This way, no
clothes can slide up and out of the drum, because of the effect of the centrifugal force.
Never fill the drum with two loads of wash facing each other.
4) With your hands dry, connect the plug to the A.C. outlet on the wall and place a bowl or vessel
under the draining spout.
5) Close the lid and, with one hand press it down and, with the other hand, turn the command lever
clockwise to position "1" (Fig. A) (the safety mechanism will not let the drum start if the lid is open
even if you turn the lever). Automatically the Spin-dryer will start working and the drying process
will begin. If you should notice a severe swaying motion, this means that clothes are not well
distributed and it will prevent the Spin-dryer from reaching the normal working speed and may result
in damage to your appliance. Stop the Spin-dryer by turning the command lever slowly to position
"O". Once the drum has stopped spinning, the lid will open by itself, disconnect the plug from the
A.C. outlet and place clothes correctly, as previously explained (Fig. B), then start the Spin-dryer
again.
6) When water stops coming out of the draining spout (3 or 4 minutes after starting, depending on
clothes), turn the command lever slowly to position "O", the drum will stop spinning and the lid will
open by itself. Disconnect the plug from the A.C. outlet and take out the clothes which will be ready
for ironing.
7) After you have spin-dried the last load and with the Spin-dryer stopped, turned off and
disconnected from the A.C. outlet, tilt it towards the spout so the rest of the water comes out.
11