Idiomas disponibles
Idiomas disponibles
1
Inserting the batteries into the remote
The remote may have a screw that secures the battery compartment cover onto the remote control (or this
may be in a separate bag). Remove the screw, if the cover is screwed on previously. Then remove the battery
compartment cover to reveal the battery compartment. Insert two 1.5V - size AAA batteries. Make sure the
(+) and (-) signs match (observing correct polarity). Do not mix old and new batteries. Replace only with same
or equivalent type. Place the cover back on. Secure the cover again with the screw, if any.
A message will be displayed on the screen when the batteries are low and must be replaced. Note that when
the batteries are low, the performance of the remote control may be impaired.
Batteries should not be exposed to excessive heat such as sunshine, re or the like.
Remove the back cover to reveal the battery compartment. You need to do the followings in order to do that:
Place the tip of a pen or some other pointed object in the hole above the cover and press it down.
Then press rmly on the cover and slide in the direction of the arrow.
Insert two 1.5V - size AAA batteries. Make sure the (+) and (-) signs match (observe correct polarity). Do not
mix old and new batteries. Replace only with same or equivalent type. Place the cover back on.
2
Connections
Antenna
Connect the antenna cable/s to your TV.
rear-left side of the TV
1. Satellite (**)
2. Aerial or cable
Power
After unpacking, allow the TV set to reach the ambient room temperature before you
connect the set to the mains. Plug the power cable to the mains socket outlet.
IMPORTANT: The TV set is designed to operate on a 220-240V AC, 50 Hz supply.
(**) Limited Models Only
-or-
HDMI connection
rear-left side of TV
External Devices
PLEASE ENSURE BOTH UNITS ARE
SWITCHED OFF BEFORE CONNECTING
Use the proper cable to connect two units together.
To select the desired input source, press the Source
button on the remote control.
English - 1 -
3
Switching on the TV
In order to turn the TV on from standby mode:
Press the Standby button on the remote control
Press the centre of the control switch inwards, located at the rear left hand side
of the TV
-or-
In order to turn the TV on from standby mode:
Press the Standby button on the remote control
Press the control button on the TV
-or-
Press the centre of the joystick on the TV in or push it up/down
-or-
Press the Standby button on the remote control.
Press the control button on the TV.
4
Internet connection
You can set up your TV so that it can access the Internet through your local area network (LAN) using a wired
or wireless connection. Refer to full user manual for detailed instructions.
Wired
Note:
Wireless
English - 2 -
