HyperMotion CLIMBER 6FT Manual De Instrucciones página 21

6. Assembly
Step 1:
Take 10 tubes (part A) and make a decagon out of them.
Step 2:
Take 1 tube (part A) and 1 tube (part B).
Join them together using one bolt (part F), one nut (part G) and two washers (part H). The order
of connecting the pipes must be as shown in the figure.
First, put the washer on the bolt. Then put the bolt through tube # 1, then tube # 2, tube # 3, tube
# 4. Then put on the washer, and finally tighten the nut by hand on the bolt.
EN 20