Idiomas disponibles
Idiomas disponibles
WARNING
Electric shock and damage to the product
possible!
Contact with a live cable during cutting can result in
electric shock. Cutting into foreign objects can cause
damage to the cutter bar.
–
Scan hedges and bushes for hidden objects, such
as live wires, wire fences and plant supports, be-
fore cutting
ATTENTION
Make sure that the ambient temperature does not ex-
ceed 50°C and does not fall below -20°C during work.
ATTENTION
The product is part of the 20V gomag series and may
only be operated with batteries of this series. Batter-
ies may only be charged with battery chargers of this
series. Observe the manufacturer's instructions.
8.1
Inserting/replacing cutting blades
(Fig. 3)
CAUTION
Wear protective gloves when handling the
blades!
To remove the blade:
1. Press the release buttons (2) on the motor/housing
(3).
2. Pull the cutting blade slightly downwards and re-
move it from the motor/housing (3).
To replace blades:
Note:
When reinserting, make sure that the sprockets fit cor-
rectly (1a/8a).
1. Insert the grass cutting blade (1) or the hedge cut-
ting blade (8) and push it towards the motor/housing
(3) until it audibly engages.
2. Check that the cutting blade is correctly seated.
8.2
Inserting/removing the battery
(11) into/from the battery mount
(7) (Fig. 2)
Inserting the battery
1. Push the battery (12) into the battery mount (7). The
battery (12) clicks into place audibly.
Removing the battery
1. Press the unlock button (11) of the battery (12) and
remove it from the battery mount (7).
8.3
Switching the product on/off (Fig.
1)
Switching on
Notes:
Before switching on, make sure that the product does
not touch any objects.
1. Pull the blade guard (9/10) off the grass cutting
blade (1) or the hedge cutting blade (8) before
switching on the product.
2. First press the switch lock (4) and then the on/off
switch (5).
Note:
It is not necessary to keep the switch lock pressed after
starting the product. The switch lock is intended to pre-
vent accidental starting of the product.
Switching off
1. To switch it off, simply release the on/off switch (5).
CAUTION
After switching off, the product will run on. Wait until
the product has come to a complete stop.
8.4
Overload protection
Note:
In the event of overloading, the motor will switch itself
off. After a cool-down period (time varies) the motor can
be switched back on again.
9
Working instructions
Note:
Some noise pollution from this product is unavoidable.
Postpone noisy work to approved and designated
times. If necessary, adhere to rest periods.
WARNING
Electric shock and damage to the product
possible!
Contact with a live cable during cutting can result in
electric shock. Cutting into foreign objects can cause
damage to the cutter bar.
–
Scan hedges and bushes for hidden objects, such
as live wires, wire fences and plant supports, be-
fore cutting
• Check the product for obvious defects such as
loose, worn or damaged parts before each use.
• Check that the screws in the cutter bar are tight.
• Blunt blades reduce the cutting performance and
impair the work process! Sure signs of blunt blades
are leaving an indentation, reduced performance
and a poor cutting pattern.
• Securely hold the product by the handle.
www.scheppach.com
GB | 25
