Idiomas disponibles
Idiomas disponibles
Installation and use
must be recalibrated.When the host is turned off,
long press the "SET" key, the machine enters the
temperature calibration mode.
Press the temperature setting key "▲▼" to calibrate
the temperature, and finally press "SET" to save and
exit the calibration mode.
Handle control operation
instructions
1 handle temperature
adjustment In working
state, press the handle
temperature adjustment button to increase/
decrease the temperature.
2 handle control machine
switch In the working state,
press and hold the two temperature adjustment
buttons of the handle at the same time to turn
on/off the interface of the host.
Tip temperature of
soldering iron
Tip temperature of soldering iron
The high temperature will weaken the tip function,
so choose the lowest possible temperature. This
tip has excellent temperature recover y and can
be fully welded at lower temperatures to protect
temperature sensitive elements.
When cleaning up
●
Use a clean sponge to clean the tip regularly.
After welding, the oxide and carbide derived
from the residual flux of the tip will damage the
tip, causing welding errors, or reduce the heat
conduction function of the tip
Clean up when not in use
Do not use the iron, do not let the iron in the
high temperature for a long time, will make
the solder on the iron head into oxide, resulting
P11
Tip temperature of
soldering iron
in the heat conduction function of the iron head
greatly decreased.
Low after use
●
After use, clean the tip of the soldering iron and
coat it with new tin layer to prevent oxidation.
Inspection and cleaning
soldering iron tip
Check and clean the tip of the soldering iron:
Note: Do not file the iron to remove the oxide.
1. Et the temperature at 250 degrees Celsius
(482 degrees Fahrenheit).
2. After the temperature is stable, clean the tip
with a cleaning sponge and check the condition
of the tip.
3. If the tin part of the soldering iron contains
black oxide, coat the soldering iron with a new
tin layer, then wipe the soldering iron with a
clean sponge until the oxide is completely removed,
then coat the soldering iron with a new tin layer.
4. If the tip of the soldering iron is deformed or
produces heavy rust, a new one must be replaced.
Replacement of heating core:
This welding table USES the heating core inte-
grated with the welding head. After power failure
and cooling, directly unplug the old one and
plug in the new one.
P12
