Aritech 6932AMP-SB Hoja De Instalación

6932AMP-SB Outdoor Curtain Dual Tech
Detector Swivel Bracket Installation Sheet
EN ES FR IT NL PL PT SV
1
B
3
2 to 4 m
EN: Installation Sheet
Package Contents
•
2 x wall mount plugs
•
2 x wall mount screws
•
1 x swivel body
•
1 x swivel plate
•
4 x plastic fixing screws
© 2021 Carrier
2
C
A
Introduction
This product is an accessory for the 6933AMP curtain detector.
A more effective presence detection can be achieved using the
swivel bracket by adjusting the detection area onto the ground
or a wall (see Figure 3). Fixed flat to a wall the detector can
pan ±45° and tilt upward 15° and downward 45°.
Mounting the Unit
The normally closed tamper can be wired in series with the
detector tamper output.
1. Use drilling template to locate the two mounting holes.
Ensure the rear tamper will be mounted flat.
2. Cut out the side or bottom knock outs for cable access if
needed. Next feed the cable and rear tamper wire through
the swivel bracket.
3. Secure the bracket to the wall using provided wall screws
(Figure 1, item A). Next fix together using four provided
fixing screws (Figure 1, item B). Tighten the bracket
(item C) then fit and wire the detector section.
Detector placement and beam patterns
Using the swivel bracket the mounting height can be increased
above 2.5 m* without compromising detection below. At 4 m
1 / 8
45°
45°
P/N 466-5593-ML • REV B • ISS 02APR21
15°
45°