Idiomas disponibles
Idiomas disponibles
NOTE
Mulching is only possible on relatively short lawns.
10.2.1
Inserting the mulching insert (13)
(Fig. 13, 15, 16)
1. Lift the discharge flap (8).
2. Remove the grass collection basket (5) (if used) by
the carrying handle (5a).
3. Lift the discharge flap (8) and insert the mulching in-
sert (13).
4. Adjust the cutting height (see 9.1).
Note:
Cut the grass back by 2 cm if the grass is 4-6 cm high.
10.2.2
Difference between lawn mowing
and lawn mulching (Fig. 13, 16)
When using the mulching insert (13), the grass clip-
pings are not collected in a grass collection bag, but
shredded and distributed over the lawn. The nutrients
contained in the grass clippings are thus broken down
by soil organisms forming a nutrient cycle. Mulched
lawns therefore need to be fertilised much less fre-
quently.
As a general rule, the lawn must be mowed relatively
often so that only small amounts of mulch remain on
the lawn. It is therefore best to mulch the lawn at least
once a week and set the mower so that only approx.
40% of the total height of the lawn is mulched. If the
mulch remains visible on the lawn (e.g. during the first
cut of the year or during heavy growth), the grass bag
(5) should be used.
10.3
Safety key (14) (Fig. 1, 17)
Note:
The product can only be started if the security key is in-
serted in the product.
1. Open the cover (7).
2. Insert the rechargeable batteries (17) as described
in 9.2.
3. Insert the safety key (14).
4. Close the cover (7).
WARNING
Danger of injury!
To switch off the product, switch off the motor, wait
for it to stop, remove the battery and pull out the safe-
ty key.
10.4
Blade-stop device (Fig. 1, 18)
Before each use, you must check the blade stop de-
vice. Start the motor as described in 10.5.
1. Release the safety bar (1). The engine switches off
and the blade (16) is braked.
34 | GB
2. The blade (16) must stop within 7 seconds.
10.5
Switching the product on/off (Fig.
18)
Note:
Switching on
1. Hold the on/off button (11) depressed and pull the
safety bar (1) rearwards.
Switching off
1. Release the safety bar (1).
2. Pull out the safety key (14).
3. Remove the battery.
CAUTION
After switching off, the product will run on. Wait until
the product has come to a complete stop.
10.6
After mowing
• Check all screws and nuts before the next use.
Tighten up loose screws.
• Empty the grass collection basket before the next
use.
• Please also observe the chapter "Storage".
11 Cleaning and maintenance
WARNING
Have maintenance and repair tasks that are
not described in this operating manual, car-
ried out by a specialist workshop. Use only
original spare parts.
There is a risk of accident! Always perform
maintenance and cleaning work with the
battery removed. There is a danger of inju-
ry! Let the Product cool down before all
maintenance and cleaning tasks. Elements
of the engine are hot. There is a danger of
injury and burning!
The product can start unexpectedly and cause inju-
ries.
–
Remove the battery.
–
Allow the product to cool down.
–
Remove the tool attachment.
www.scheppach.com
