Care & Maintenance; Cleaning After A Brew; Cleaning Your Carafe; Cleaning Your Water Reservoir - Ninja COFFEE BAR CF060EU Manual De Usuario

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 32
Care & Maintenance
H
M
Fig. 21

CLEANING AFTER A BREW

CAUTION: Make sure that the brewer is unplugged
from the power source before cleaning.
CAUTION: Be sure to allow the brewer to cool before
cleaning.
IMPORTANT: Discontinue use if the glass carafe is
scratched or handle is loose or damaged.
NOTE: Do not leave coffee in the glass carafe for an
extended period of time after a brew.
NOTE: Do not leave water in the reservoir unused for
multiple days. Rinse and replace with fresh water.
1
Before cleaning, close the Drip Stop.
2
After each brew is complete and the coffee grounds have
cooled, carefully remove the brew basket from the brewer,
discard the coffee grounds, rinse and wash with warm soap
and water.
NOTE: The brew basket is not dishwasher safe.
NOTE: The flip top water resevior lid is not dishwasher
safe
NOTE: If coffee grounds spilled over into the brew basket or
in the overflow channels, remove and rinse under water until
grounds are removed.
3
Wash the carafe and brew-through lid with soap and warm
water. Use a bottle brush or a cloth to wash the inside of the
carafe.
NOTE: The brew-through lid, glass carafe and water reservoir
are top shelf dishwasher safe.
IMPORTANT: Clean the glass carafe with a soft brush or
sponge. Do not use a wire brush.
4
Wipe machine down with a warm cloth with soap and water.
Let the warming plate cool before cleaning with a wet cloth
and soap and water. Do not immerse the base in water.
NOTE: For best results, use a bottle brush. This will allow you
to scrub all of the inside with soap and hot water.

CLEANING YOUR CARAFE

We recommend rinsing your carafe with warm
soapy water, or placing in the top shelf of your
dishwasher. If you want to clean the carafe more
thoroughly, we recommend using a soft foam brush
such as the one shown.
58

CLEANING YOUR WATER RESERVOIR

1
Empty the water reservoir.
2
Hand wash with dish soap and rinse or place on the top rack
of your dishwasher.
HOW TO CLEAN & DESCALE THE BREWING SYSTEM
CAUTION: Be sure to allow the brewer to cool before
cleaning.
CAUTION: DO NOT immerse the coffeemaker into water
or any other liquid.
NOTE: Cleaning and descaling shall be performed on
a weekly basis. Cleaning your Ninja Coffee Bar
®
is
recommended to keep your brewer brewing hot, rich, and
smooth coffee.
The Clean button will illuminate when your Ninja Coffee Bar
senses there is a calcium build up on your machine, that
could be affecting the flavour of your coffee. To clean your
machine and keep the same great taste of Ninja
coffee,
®
follow the directions below.
1
Select the carafe size and set the carafe in place beneath the
brew basket.
2
Use a descaling solution and follow the directions on
the package and fill up to, but not exceeding the Max
Fill line (1.35 L).
OR
Fill the water reservoir to the mug line (325 ml) with white
vinegar, then fill the rest of the water reservoir with water up
to, but not exceeding the Max Fill line (1.35 L).
IMPORTANT: Use only white vinegar.
3
Once the water reservoir is filled with your cleaning solution
and water mixture (not exceeding the Max Fill line), simply
press the Clean button to activate the clean cycle. (Fig. 21)
NOTE: The clean cycle takes approximately 8 minutes to fully
descale and clean the machine.
4
Once the clean cycle is complete, empty and rinse the carafe
and water reservoir. Please take special care to thoroughly
clean the carafe and water reservoir to remove any cleaning
solution that could affect the flavour of your coffee.
5
Once the clean light turns off, fill with fresh water up to, but
not exceeding the carafe line (1.35 L Max Fill line) and run 2
or 3 clean cycles with fresh water to rinse. Discard the water
in the carafe after each cycle.
NOTE: If the Clean light illuminates on the next brew after
a clean cycle, this means there is still calcium build up on
the brewer. Repeat steps above and the clean light will
automatically shut off when it senses your Ninja Coffee Bar
is clean and free of calcium build up!
If you continue to use your Ninja Coffee Bar
®
after the Clean
light has illuminated it will continue to remain illuminated
and over time it will alert you to clean and descale your unit
through a series of beeps.

Troubleshooting Guide

PROBLEMS
If there is sediment at the bottom of the brewed coffee, this may be due to finely ground coffee in a
permanent filter.
Sediment in my coffee.
To reduce the amount of sediment in the brewed coffee use a slightly coarser grind or use a paper
filter.
If there are grounds in your coffee, check to make sure the brew basket did not overflow.
If there are too many grounds in the brew basket, or you are using a fine ground coffee, the
Grounds in my coffee.
grounds will flow into an overflow channel designed to make sure overflow is captured in the brew
vessel. For best results use medium ground coffee in the recommended measurements.
Check to see if the Drip Stop toggle is set to the closed, no drip position.
Brew Basket dripping
®
If the Drip Stop is set to the closed, no drip position and the brewer continues to drip, run a clean
after brew.
cycle or wash the brew basket thoroughly with warm, soapy water.
To keep your coffee hotter longer, preheat your mug or carafe by rinsing it with hot water from
the  tap.
Coffee is not hot
If using a microwave safe mug with milk, try preheating the milk in the microwave for 30 seconds.
enough.
NOTE: Never place carafe in the microwave.
The Over Ice Brew is designed to brew hot coffee over ice to lock in the flavour for rich, smooth
Over Ice Brew is not
iced coffee. Make sure your mug, travel mug, or carafe is filled all the way to the top with ice
cold.
cubes.
If the coffee tastes weak, try adding more coffee grounds into the brew basket for the next
brew cycle.
Weak coffee.
If the coffee is still weak after adding more coffee grounds, try Rich Brew to make a stronger more
concentrated mug.
Try using a more coarse grind.
Coffee too strong.
If the coffee is still too strong, try using less coffee grounds.
Check to make sure the brewer is plugged in and water is in the water reservoir.
If the drip stop is in the open position, check that the brew basket is pushed all the way into the
brewer.
Brew will not start.
If you hear 5 beeps, check that the drip stop is in the open position.
NOTE: The brew will begin, stop, and be quiet for a short period of time before it begins again. This
process is used to evenly saturate your coffee grounds.
A carafe brew will take approximately 8 minutes and the single mug will take approximately 4
minutes.
Brew cycle is too slow.
If the brew cycle is taking longer than normal, run the clean cycle with the descaling solution.
®
POSSIBLE REASONS & SOLUTIONS
www.ninjakitchen.eu
59
Tabla de contenido
loading

Tabla de contenido