Idiomas disponibles
Idiomas disponibles
EN
7. FITTING REQUIREMENT - Worktop
Safety instructions for the kitchen
furniture fitter
-
Veneers,
adhesives
coverings of adjacent furniture must
be temperature-resistant (min. 75°C).
If the veneers and coverings are not
sufficiently
they may deform.
- The use of solid wood wall end strips
on the worktop behind the hob is per-
mitted, provided that the minimum
distances
are
cordance with the installation sket-
ches.
- The minimum distances of the trough
cut-outs to the rear according to the
installation sketch must be observed.
- For installation directly next to a tall
cabinet, a safety distance of at least
50 mm must be maintained. The side
surface of the tall cabinet must be
covered with heat-resistant material.
For technical reasons, however, the
distance should be at least 300 mm.
- The distance between the hob and the
cooker hood must be at least as large
as specified in the installation instruc-
tions for the cooker hood.
- The packaging materials (plastic film,
polystyrene, nails, etc.) must be ta-
ken out of the reach of children, as
these
parts
sources of danger.
could be swallowed and suffocation is
caused by foils.
Ventilation
- The induction hob has a fan that auto-
matically switches on and off. If the
temperature values of the electronics
exceed a certain threshold, the fan
starts at a low speed. If the induction
hob is used intensively, the fan swit-
ches to a higher speed. If the electro-
nics have cooled down sufficiently,
52
or
plastic
temperature-resistant,
observed
in
represent
possible
Small
parts
the fan reduces its speed and swit-
ches off again automatically.
- The distance between the induction
hob and kitchen furniture or built-in
appliances must be chosen so that
sufficient ventilation of the induction
is guaranteed.
- If the power of a cooking zone is fre-
quently automatically switched down
ac-
or off (see chapter Overheating pro-
tection), the cooling is probably not
sufficient. In this case, it is advisable
to open the rear wall of the base ca-
binet in the area of the worktop cut-
out and remove the front crossbar of
the furniture across the entire width
of the hob to ensure better air
exchange.
For better ventilation of the hob, an air
gap of at least 5 mm is recommended at
the front.
