Idiomas disponibles
Idiomas disponibles
Before first use
1. Unpack the appliance, then check and make sure that all the accessories including ice
basket and ice scoop etc. are complete. Please contact with the client service
department if some accessories are missed.
2. Please follow the operation as below to install the handle well in position.
1) Grasp both sides of the handle shown in arrows with hands and pull them outwards
(see Fig.1).
2) Make the handle align with the holes at the housing and release the hands, then
the handle is inserted into the holes of housing (see Fig.2).
3) Pull and make the handle be upright, then pull both sides of the handle outwards
by following the operation of Step 1). Check and make sure that the handle shall be
positioned well at the holes of housing.
4) Grasp the centre of handle and lift it upwards (see Fig.3), check and make sure that
there shall be no abnormal condition can be found.
Fig.1
3. Please ensure the ice maker is level and on a stable table or platform to avoid
malfunction.
4. The incline angle of the ice maker cabinet should not exceed 45°during transportation
or use. Do not turn the ice maker upside down. Doing so could cause the compressor
or refrigerating system to operate incorrectly. Please allow time for the fluids in the
compressor to settle after the ice maker is moved or transported. Before using the ice
maker for the first time, please wait for 2 hours after the unit has been levelled and
positioned in the proper place.
5. The appliance must be placed on a dry and level surface with sufficient ventilation, far
from heat sources such as ovens, heaters and corrosive gases. Leave a 6-inch (15cm)
clearance on all sides of the ice maker for proper ventilation.
6. Do not fill the water reservoir with hot water. This may damage the ice maker. It is best
to fill the water reservoir with water of room temperature or lower.
7. Do not use the appliance at a very cold environment (lower than 5℃).
8. Clean the appliance by following the operation of "CLEANING AND MAINTENANCE"
before operate.
Fig.2
English - 7 -
Fig.3
