Idiomas disponibles
Idiomas disponibles
9.5. Trouble Shooting and Remedy
In case of errors/troubles not mentioned above, please contact your local service technician for further assis-
tance.
9.6. Service address
Please see the back cover of this manual
Symptoms
The unit does not start
The "Δ" lamp on the controlpanel is
flashing
No pressure/too low pressure
Possible Causes
Is there voltage to the unit
•
Fuse blown
•
Display lights up, but the unit
•
does not start after reconnect-
ing voltage
Unit starts after changing
•
startup method
•
After reactivating flow start
Error messages on display
•
Error after restart
•
•
Insufficient or No water supply
•
Is the filter if any clogged
Is the pump leaking or making
•
jarring sounds
Rinsing nozzle not installed
•
Remedy
Reconnect voltage
•
Call technician
•
Go to setup -> Settings menu
•
-> Startup method,
and set it to pressure
Set unit back to flow start in
•
setup menu
•
Try to re-adjust flow switch
Press "0" wait for a few sec-
•
onds and then press "1"on
the control panel to restart the
system.
Go to software manual
•
•
Open water supply valve
•
Clean the filter
Call technician
•
Place rinsing nozzle
•
19
