Idiomas disponibles
Idiomas disponibles
7
Unpacking
WARNING
The product and the packaging material are not
children's toys!
Do not let children play with plastic bags, films or
small parts! There is a danger of choking or suf-
focating!
• Open the packaging and carefully remove the prod-
uct.
• Remove the packaging material, as well as the
packaging and transport safety devices (if present).
• Check whether the scope of delivery is complete.
• Check the product and accessory parts for transport
damage. Immediately report any damage to the
transport company that delivered the Product. Later
claims will not be recognised.
• If possible, keep the packaging until the expiry of
the warranty period.
• Familiarise yourself with the product by means of
the operating manual before using for the first time.
• With accessories as well as wearing parts and re-
placement parts use only original parts. Spare parts
can be obtained from your specialist dealer.
• When ordering please provide our article number as
well as type and year of manufacture for the prod-
uct.
8
Assembly
DANGER
Danger of injury!
If an incompletely assembled product is used, serious
injuries can be caused.
–
Do not use the product until it has been fully fitted.
–
Before each use, carry out a visual inspection to
check that the product is complete and does not
contain any damaged or worn components. Safe-
ty and protective devices must be intact.
WARNING
Danger of injury!
Remove the battery from the power tool before carry-
ing out any work on the power tool (e.g. maintenance,
tool change, etc.) and when transporting and storing
it. There is a risk of injury if the on/off switch is oper-
ated unintentionally.
36 | GB
WARNING
Always make sure that the tool attachment is fitted
correctly!
• Place the product on a level, even surface.
8.1
Fit the chainsaw guide bar (16)
and saw chain (17) (Fig. 2-5)
WARNING
Danger of injury when handling the saw
chain or the blade!
–
Wear cut-resistant gloves.
ATTENTION
Blunt blades overload the product! Do not use the
product if the cutters are faulty or heavily worn.
Notes:
• A new saw chain stretches and needs to be re-ten-
sioned more often. Check and adjust the chain ten-
sion regularly after each cut.
• Only use saw chains and blades designed for this
product.
CAUTION
An incorrectly installed saw chain leads to uncon-
trolled cutting behaviour by the product!
When fitting the saw chain, observe the prescribed
running direction!
To fit the saw chain, it may be necessary to tilt the
chainsaw to the side.
1. Turn the chain tensioning wheel (18) anti-clockwise,
so that the chain cover (21) is removed.
2. Lay out the saw chain (17) in a loop so that the cut-
ting edges are aligned clockwise. Use the symbols
(arrows) above the saw chain (17) as a guide for
aligning the saw chain (17).
3. Place the saw chain (17) in the groove of the chain-
saw guide bar (16).
4. Fit the chainsaw guide bar (16) onto the guide pin
(23) and the stud bolt (24). The guide pin (23) and
the stud bolt (24) must be in the elongated hole on
the chainsaw guide bar (16).
5. Guide the saw chain (17) around the chain wheel
(22) and check the alignment of the saw chain (17).
6. Fit the chain cover (21) back on. Make sure that the
groove on the sprocket cover (21) sits in the recess
on the motor housing.
7. Tighten the chain tensioning wheel (18) clockwise
hand-tight.
www.scheppach.com
