Idiomas disponibles
Idiomas disponibles
DIAMOND BLADES
• Use only 7 in. (180 mm) continuous rim
diamond blades with a 5/8" arbor opening
in this saw. Failure to do so may result in
severe bodily injury and damage to the saw.
• The diamond blade that comes with this saw
will cut ceramic, porcelain and marble tile.
Due to the hardness of some porcelain, slate
and stone, purchasing a blade specifically
designed to cut these hard tiles, will speed
up the cutting time required. IMPORTANT:
Always let the blade cut at its own speed,
moving the material slowly into the blade. Do
not force the material being cut.
DIAMOND BLADE DO'S &
DON'TS
1. DO inspect blades daily for cracks or
uneven wear. Discard cracked, chipped or
bent blades!
2. DO use manufacturer's recommendation
for matching the right blade with the right
material being cut.
3. DO inspect the arbor shaft for uneven wear
before mounting the blade.
4. DO use blades with the correct arbor size
on a compatible arbor shaft.
5. DO ensure the blade is mounted with the
rotation arrow in the proper direction and is
securely tightened with a wrench.
6. DO wear proper safety equipment at
all times when operating the saw. Wear
goggles and dust mask at all times when
operating saw.
7. DO periodically check the blade for cracks
or bond fatigue.
8. DO ensure that blade is traveling through
water reservoir for wet cutting.
1. DO NOT operate the saw without all safety
guards in position.
2. DO NOT operate the saw with blades larger
or smaller than recommended.
3. DO NOT cut dry with blades marked
"Use Wet."
4. DO NOT exceed maximum RPMs recom-
mended by the blade manufacturer.
5. DO NOT force the material into the blade.
Let the blade cut at its own speed.
6. DO NOT cut material not recommended by
the blade manufacturer.
– 5 –
TROUBLESHOOTING
OVERHEATING OF SAW:
1. Turn saw off and let it rest until motor is
cool to the touch.
2. Check and clean the ventilation slots,
removing blockage and dirt.
THE SAW DOES NOT START:
1. Check that power cord is properly
plugged in.
2. Check outlet power source and circuit
breaker.
3. Make sure yellow safety key is fully pushed
into switch.
CUSTOMER SERVICE:
1-866-435-8665
