Idiomas disponibles
Idiomas disponibles
GB
1. General information
1.1 Safety warnings and operating instructions
This product should be installed preferably by a qualified professional. Subject to observation of the above terms, the
manufacturer shall assume the liability for the equipment as provided by legal stipulations.
All instructions in this Installation & Operation manual should be observed when working with the controller.
Failures due to improper installation, improper use or poor maintenance are voiding manufacturer liability.
Any attempt to repair voids the responsibility and the obligation to guarantee and replacement from the manufacturer.
2012/19/EU (WEEE directive): Products marked with this symbol cannot be disposed of as unsorted municipal waste in
the European Union. For proper recycling, return this product to your local supplier upon the purchase of equivalent new
equipment, or dispose of it at designated collection points. For more information see: www.recyclethis.info
1.2 Application
The controller has been designed for use in residential rooms, office spaces and industrial facilities. Verify that the instal-
lation complies with existing regulations before operation to ensure proper use of the installation.
2. Presentation
The SH-HCM is especially designed to control heating and cooling in combination with SH-CD controllers. The targeted
application is thus 2 pipes multi zones water floor heating and cooling. This device is an option and only one module is
possible per installation. It should be installed near the heating and cooling source (heat pump) whereas the SH-CD6
controllers should be installed near the manifolds. The device is an option with 3 main value proposals:
• Separate heating and cooling signal
• Global dehumidifier control
• Global Heating & cooling mode control
2.1 Functions
It has integrated multiple functions:
• Wall mounted or mounted on DIN Rail
• Push-in cable connections with strain relief
• LED status indication and DIP switch for device setting
• H&C input (230 V and volt free signal)
• Humidity input (Volt free contact) or water temperature measurement (Probe not supplied) for humidity detection
• Dehumidifier output
• Pump or boiler output (230 V and volt free signal)
• Heating output and cooling output
• Internal RF antenna, optional external antenna
12
