Idiomas disponibles
Idiomas disponibles
Instead, add a hose and coupling between the tool and the air supply. The recommended
hook-up is shown in figure A. Pneumatic tools operate on a wide range of air pressures. For
maximum efficiency and longer tool life, the pressure of the air supplied to these tools should
not exceed the rated PSI at the tool when the tool is running.
Using a higher than rated pressure will cause faster wear and drastically shorten the tool's
life. A higher air pressure can also cause an unsafe condition. The inside diameter of the hose
should be increased to compensate for unusually long air hoses (over 25 feet). Minimum hose
diameter should be 3/8" I.D. and fittings should have the same inside dimensions. The use of air
line lubricators and air line filters is recommended to prevent water in the line that can damage
the tool. Drain the air tank daily. Clean the air inlet filter screen on at least a weekly schedule to
remove accumulated dirt or other matter that can restrict air flow.
It is strongly recommended that a regular service programme for all air powered tooling
be adopted and managed, as reqularly maintained air tools ensure a long life cycle, optimal
power and reduced operating expenses. Repairs of air tools should be carried out by trained
specialists and authorized service dealers. For this reason, we strictly advise against attempting
to repair without this support. Pour a liberal amount of air tool oil in air inlet. If tool remains
jammed, it should be serviced by an authorized service Center. If operation cannot be restored,
tool should be checked by the fabricant or an authorized service center.
12
SERVICE AND MAINTENANCE
