Tabla de contenido
Idiomas disponibles
Idiomas disponibles
The battery must be charged before first use.
Inserting the battery into the machine (Fig. B)
Ensure that the exterior of the battery is
clean and dry before connecting to the
charger or machine.
1. Insert the battery (2) into the base of the machine
as shown in Fig. B.
2. Push the battery further forward until it clicks
into place.
Removing the battery from the machine (Fig. B)
1. Push the battery unlock button (3)
2. Pull the battery out of the machine like shown
in Fig. B.
Checking the battery charging status (Fig. C)
• To check the battery charge status, push the
button (11) on battery shortly.
• The battery has 3 lights indicating the charge
level, the more lights that burn, the more charge
the battery has left.
• When the lights are not burning it means the bat-
tery is empty and must be charged immediately.
Charging the battery with the charger (Fig. C)
1. Take the battery (2) from the machine.
2. Turn the battery (2) to upside down position and
slide it onto the charger (13) as shown in Fig. C.
3. Push the battery until it is fully pushed into the
slot.
4. Plug the charger plug into an electrical outlet and
wait for a while. The LED indicators on the charger
(14) will lighten up and show the charger status.
The charger has 2 LED indicators (14) which indica
te the status of the charging process:
Red LED Status
Green LED status
Off
Off
Off
On
On
Off
WWW.VONROC.COM
• Fully charging the 2Ah battery may take up to
60 minutes.
• Fully charging the 4Ah battery may take up to
120 minutes.
After the battery is fully charged remove the char-
ger plug from the outlet and remove the battery
from the charger.
Fitting and removing drills or screwdriver bits (Fig. A)
The drill chuck (7) is suitable for drills and screw-
driver bits with round shaft as well as hexagonal
shaft.
1. Hold the machine firmly with one hand.
2. Open the drill chuck (7) by rotating the chuck
with your other hand in clockwise direction until
it is opened far enough for the bit to slide in.
3. Insert the shaft of the drill or screwdriver bit.
4. Tighten the drill chuck again by firmly rotating
the chuck (7) counterclockwise.
5. Check if the bit is centered well by shortly acti-
vating the machine´s on/off switch.
4. OPERATION
Adjusting the gears (Fig.A)
The machine has 2 drill speeds, which can be
adjusted by sliding the gear switch (8) forward
or backwards. The number on the gear switch (8)
Charger status
shows which position is chosen.
No power
• Position 1: For slow drilling, large drilling dia-
meter or screw driving. The machine has high
Standby mode:
power at a low speed.
- No battery is
• Position 2: For fast drilling or small drilling
inserted or,
diameter.
- Battery inserted
but charging has
Adjusting the direction of rotation (Fig. A)
finished
• Set the direction switch (9) to position
Battery charging in
order to drive screws or to use it for drilling.
progress
• Set the direction switch (9) to position
order to remove screws.
When the machine is not being used over a
longer period of time it is best to store the
battery in charged condition.
Never switch gears when the motor is
running, this will damage your machine.
Never put switch in the middle between both
positions, this will damage your machine.
EN
in
in
7
Tabla de contenido
