Beper 50.810 Manual De Instrucciones página 18

Steam iron Use instructions
When used for the first time, press several times steam switch, in order to eliminate dirt, residue
from the manufacture.
Steam ironing is possible when setting the thermostat on symbol (•) ; when the temperature increa-
sed the steam also increase until symbol max. (•••).
The light indicator illuminate and when the soleplate is at good temperature switch off.
Pressing the steam switch, steam function is activated.
Set the temperature indicator at least on position "•••".
Wait 5 seconds between steam spray and the one other after.
If steam switch is pressed before reaching the setting temperature, steam function won't work but
only water drops; that could stain clothes.
Water drops may result of a non-stop pressure of steam switch, by more than 5 seconds.
To obtain a non-stop steam, keep steam indicator in position
ATTENTION : always direct the steam to clothes and not in direction of face.
When finished using the iron, unplug the appliance and empty the tank water.
WATER SPRAY
Check that the tank is full of water, direct the spray forward the clothes. Press several times the
water switch.
When used for the first time, it is recommended to press several times on water switch before you
obtain the desired spray.
Attention: do not use water spray function on silk.
DRY IRONING
Set the steam indicator on in order to not to use steam function. Set the soleplate temperature
by using the thermostat .
The light indicator illuminates and switch off when the soleplate is at good temperature.
Start ironing after iron reached desired temperature.
Please note that the soleplate reached lower temperatures when used without steam.
FILL AND EMPTY THE TANK
This has to be made only when the appliance is unplugged.
Always dry the iron or hands before unplug the appliance after filling the tank.
Make sure the temperature indicator is on "min" and steam indicator is on
Raise the tank lid and slowly fill using a funnel FIGURA 2
Do not exceed the maximum limit of the tank.
Do not introduce water into the iron, because of electric shock risks. Close the tank lid when is full
and plug the appliance to the socket.
It is possible to use tap water as well as demineralised water if tap water is to hard.
18