Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

5.2.
Ash in the fireplace.
When opening the door, you reach the burn pot where combustion takes place; hoover it and remove it
(make sure you'll put it back properly) in order to clean all holes; make sure they're clean and hoover the
support of the burn pot as well.
5.3.
Fireplace door.
Clean the glass with a towel, using a liquid for glass cleaning, always when cold.
The handle, though adjusted with an auto-blocking screw, should be revised periodically to be adjusted
whenever needed so as to remain tight.
5.4.
Ash box.
In models in this manual, you can access to the ash box by opening the door of the fireplace.
Ash box.
IMPORTANT: If the stove is operating while full of ash or residues, that might stretch the burn pot and its
support, the ash box and even the burn pot, being the cause of bad operation or possible breakdown, wouldn't be
under warranty.
This is necessary to ensure correct operation and maintain the stove's life duration. When winter ends,
contact your provider (if he did not contact you) and meet to carry out this maintenance; the following shall be done
(the stove must always be disconnected from power):
5.5.
Opening of the side doors. CAUTION! (WE MUST UNPLUG THE STOVE BEFORE PERFORMING THIS
OPERATION).
Remove two screws on each side of the stove, which are located on the front of the liner.
5.6.
Cleaning the fireplace.
In addition to daily cleaning carried out with great attention, the following items must be cleaned:
 Heat exchanger pipes. By activating the drawers of the rake. If you have a P65 or P70 model, remove the
top plate of the fireplace as indicated in section 5.1.
 Burn pot.
 Burn pot support.
 Ash box.
 Screws of Mobile parts.
 Air entrance pipe.
MAINTENANCE AT END OF SEASON OR EVERY 500 KG OF FUEL.
Drawing 11
29
Drawing 12
Tabla de contenido
loading

Este manual también es adecuado para:

P70P90

Tabla de contenido