Idiomas disponibles
Idiomas disponibles
Dwg. 1:
Dwg. 4:
Dwg. 6:
The 022-7025 allows for safe and hands free climbing on vertical structures. In the event of an accident, any fall will be immediately arrested. It is necessary to use
this device in combination with a shock absorber to be ANSI Z359.15-2014 compliant. The user must always ensure they are at a lower level than the 022-7025.
Maximum working angle between user and device must not exceed 30°. NEVER work above the device!
User must ensure the VLL does not come into contact with any sharp or abrasive surfaces. The Drift Rope Grab will automatically trail the user as they move up
and down the VLL. To stop the trailing function of the 022-7025, rotate the mode control switch to the HOLD position. As the user needs to move up or down the
VLL, they must rotate the mode control switch back to the TRAIL position (Dwg. 3).
To remove the Drift Rope Grab from the VLL, rotate the sliding plate open (Figure 14). DO NOT ATTEMPT TO DISCONNECT WHILE IN USE!!
12.6 DRIFT ROPE GRAB (USE IN ASSISTED RESCUE)
The Drift Rope Grab is suitable for use in rescue operations. However, if used to facilitate descent to an injured worker, the Backup Anchor Descent Cord should be
utilized. The Backup Anchor Descent Cord is simple to install and is included with the grab at time of shipment.
To install the Backup Anchor Descent Cord, tie a knot at one end of the cord. Thread the untied end of the cord through the pre-drilled hole on the grab from the
inside out. Pull the cord through the hole until the knotted end of the rope cinches against the plate of the grab.
Figure 15 illustrates the proper installation and use of the Backup Anchor Descent Cord.
Dwg. 2:
Dwg. 5:
Dwg. 7:
FIGURE 14 - DISCONNECTION FROM VLL
V5.0 2023 Copyright Safewaze
Dwg. 3:
TRAIL
and
HOLD
Mode Control
Switch
WARNING INDICATOR
Dwg. 8:
STOP!
022-7025
Page 13
