Editing Output (Zone) Settings
You can use Zonetech's display, Info knob, and Left/Right (/) buttons to edit the settings
of each output (zone):
To select a zone to edit, press the corresponding Zone button (1–6). The display will
indicate which zone is selected: Zone 1–6.
To show the previous or next setting for the selected zone, use the Left/Right (/)
buttons (respectively). Turn the Info knob to adjust the value of each setting.
Note: To control the zone settings remotely, you can also use a web-based interface
on your computer (connected to the Computer Ethernet port), one Rane DRZH remote
control per zone (connected to the Zone Remotes ports), or up to two Rane DR6 master
remote controls (connected to the Master Remote and Pager ports).
These are some of the editable zone settings which are most commonly used. The
abbreviated name (shown when the setting is not selected) is in parentheses.
Note: For the complete list of settings shown in the display and their functions, download the
full User Guide.
Output Level (Level)
This is the output volume level: -30.0 to +12.0 dB
(default: 0.0 dB). This is the master volume of the
zone.
Input Source (In Source)
This is the audio source of the zone: Input 1–6 or
Stream.
For each zone, you can also adjust the settings for
Priority Source, Paging, and Limiter. Additionally,
you can adjust the Output Mode and Crossover
settings for Zone 6.
8