Idiomas disponibles
Idiomas disponibles
When over-discharge, over-charge, over-
temperature and low-temperature faults occur while
the battery pack is being charged on the charger or
used on the machine, the user will receive a fault
prompt, and the charger or the machine will stop
charging or working.
The Li-Ion battery can be charged at any time
without reducing its service life. Interrupting the
charging procedure does not damage the battery.
The battery level can be detenmined from the
battery indicator light by pressing the power test
button. Before starting or after use, press the power
test button on the battery pack to check the battery
capacity.
Remarks
LED light
Five green
lights are
illuminated.
Four green
lights are
illuminated.
Three green
lights are
illuminated.
Two green
lights are
illuminated.
One green
light is
illuminated.
One green
light is
flashing.
You can see the relevant status of the battery
through the status of the Bluetooth indicator light
and the fault indicator light.
Remarks
Bluetooth indicator
light is illuminated.
Bluetooth indicator
light is not illuminated.
Fault indicator light is
illuminated.
Battery condition
80% ≤ Power level ≤
100%
60% ≤ Power level < 80%
40% ≤ Power level < 60%
20% ≤ Power level < 40%
10% ≤ Power level < 20%
0% ≤ Power level < 10%
Battery condition
Bluetooth is connected.
Bluetooth is not
connected.
Battery failure, prohibit
charging and discharging.
Fault indicator light is
not illuminated.
When the battery pack fails, the fault indicator will
light up, and you can view the specific fault cause
and solution through the APP.
HOW TO CHARGE THE
BATTERY
Refer to the instruction manual for charger.
STORAGE
Store the battery only within a ambient temperature
range between 5~25°C.
When kept out of the charger or left in an
unplugged charger for a long time, the battery still
reaches a relatively high level.
A significantly reduced working period after
charging indicates that the battery is used and must
be replaced.
TRANSPORT
The contained Li-Ion batteries are subject to the
dangerous goods legislation requirements. The
user can transport the batteries by road without
additional requirements.
Dispatch batteries only when the battery housing
is undamaged. Pack up the batteries in such a
manner that cannot move around in the packaging.
MAINTENANCE AND
SERVICE
Occasionally clean the venting slots of the battery
using a soft, clean and dry brush.
When the dust filter on the battery is blocked, it
needs to be removed and rinsed with water. After
drying, put the dust filter back into the battery. To
protect the battery, if the dust filter is damaged,
please replace it in time. (See Fig. A)
It is normal.
7
EN
