Idiomas disponibles
Idiomas disponibles
C
Cleaning and maintenance
Cleaning and maintenance
• Disconnect the appliance from the mains, before cleaning.
• Do not use solvents or abrasive products to clean the iron, clean
with a damp cloth.
Defects and repairs
Do not attempt to replace a defective mains lead. The appliance
has to be returned to an authorized service centre for repair.
Troubleshooting
Problem
Iron emits an odor or smoke
Iron does not heat
Iron does not steam
Burst of steam feature does
not work
Spry mist feature does not
work
Iron is leaking
The steamer does not heat up
Solution
• Iron gives off an odor when turned on for the first
time. Oils used during manufacture need to be burnt
off allow ten minutes for odor to disappear.
• The iron should be plugged into a 220 Volt, AC
electrical outlet only. The temperature dial must be
set at the desired temperature.
• The water tank may be empty. Turn the steam valve
to "0" and add water. Allow the iron to heat, and then
set the steam dial to the steam setting.
• The water tank must be at least 1/4 full.Temperature
must be set to steam position. Iron should be in the
horizontal position. Prime pump briefly. Allow a short
pause between shots. Be sure to fully depress the
burst of steam button.
• The water tank must be at least 1/4 full. Fill the iron as
described in the section "how to fill the water tank".
• The variable steam dial must be set on "0",until the
iron is hot. The temperature setting is too low to
produce steam. Shot of steam used too much, allow
iron to re-heat.
• Check main plug is inserted correctly.
• Check power supply.
• Check power button.
8
EN
