Idiomas disponibles
Idiomas disponibles
10. ASSEMBLY INSTRUCTION
1. Insert the legs into the main structure
2. Insert the backrest
3. Insert the toilet stand, checking that it is properly fitted between the horizontal rails
4. Assemble the seat and seat cover of the toilet stand.
11. SEAT
Press the safety clip to adjust the height of the chairs by removing the inner part of the leg and
bringing the holes to the desired height. Check that all four legs are adjusted to the same height.
12. USING WARNINGS
•
Use caution on wet and slippery surfaces
•
DO NOT use with patient who exceeds the weight indicated in the product
label and in the technical features chapter of the present manual
•
The chair can be used only on a hard, flat surface. Do not use the chair on stairs, inclines or declines
•
Do not use the chair in a way other than that described in this manual
We disclaim any responsibility for improper use of the chair
•
Avoid to leave the device in contact with water for long periods of time
•
Periodically check the stability and hardness of the product as well as the status of the tips
and castors. Replace worn once
•
In case of doubts about use, adjustment or maintenance, contact your dealer
•
Keep it away from children to avoid any possible risks
13. HOW TO USE
•
Setting out to sit with your weight on the seat assembly.Do not sit by pushing on one side only
•
Leaning always on both arms to get up and keep your balance
•
In case of use of the chair by people with movement difficulties, help them always in the
sitting or in getting up from the chair
CAUTION!
Do not move the aid with the patient seated
14. MAINTENANCE
The MOPEDIA devices by MORETTI are checked carefully and supplied with EC mark, once
launched on the market. For patient and physician's safety we recommend to let check the device
by the manufacturer or by laboratory authorized every 2 years.
For periodic inspection means an examination of the following parts:
• The frame of the chair and connecting parts
• Check mounting and operation of the wheels with its brake
• Check all the welding points
• Check the wear of the tips where present
In case of repair, use only original spare parts and accessories.
15. CLEANING AND DISINFECTION
15.1 Cleaning
To clean the aid and the structure use neutral soap (in equal parts) mixed with water.
WARNING!
Do not use abrasive substances, acids, alcohol, chlorine-based cleaners, disinfectants
and acetone when cleaning, because these substances cause the abrasion of the plastic
surfaces and rusting of metal surfaces
The manufacture company cannot be held responsible for the damage that is caused by using
materials that could damage the product surface or corrosive chemicals during cleaning.
5
