EDM Product 07188 Manual De Instrucciones página 16

Split cerámico calefacción
Idiomas disponibles

Idiomas disponibles

CHARACTERISTICS
ES
▶Power: 1,000/2,000W
▶2 levels
FUNCTIONING
PT
▶Before connecting the device to the network, make sure that the
switch is in the "0" position.
▶Plug the power cord into the AC 220-240V~ 50Hz outlet.
EN
▶Through the 2 power system you can start the appliance.
• POSITION 0: OFF position, no button pressed.
• FRESH AIR POSITION: air fan
FR
• POSITION 1: first speed -1,000W
• POSITION 2: second speed - 2,000W
▶If you do not use the appliance for a long time, unplug the power
cord from the electrical outlet.
▶Never try to disassemble the device.
▶If you notice any abnormality (such as unusual noise from the
device), turn off the device and unplug it immediately.
▶Do not use this heater with a programmer, timer or other device that
switches the heater on automatically, as there is a risk of fire if the
heater is covered or positioned incorrectly
▶Make sure that no objects or liquids get inside the appliance through
the openings.
▶The device must only be used in dry environments. Do not use in the
immediate vicinity of a bathtub, shower or swimming pool
▶Protect the device from dust, moisture, sunlight, and direct heat.
INSTALLATION
▶Drill two holes on the wall and have a distance of more than 2m from
the ground. The hole diameter only contains the dowel, the diameter
of which is 6mm. After placing the dowel, fix it with a screw.
▶Use the machine components (screws and plugs) fix on the wall as
shown in the following figure, then assemble the appliance.
1. The distance between the product and the ceiling (and the
side) should be ≥30 cm.
2. Product installation size see figure.
Instruction manual
3. When the product is installed, the screw is aligned with
the hole "A" on the product. After hanging up, you need to
move to "B", to fix firmly.
▶When you want to remove the appliance, it should be moved from
REMOTE CONTROL
▶The appliance will turn on and fresh air will come out by default. If
Observations
▶Press
"B" to "A".
ON/OFF
you press it again, the device turns off.
OPEN WINDOW DETECTION
• 1. Open window detection can only be started when the appliance
is in heating mode (cannot be turned on when operating as fan) or
set temperature mode.
• 2. Press
, to enable open window detection, or turn off
detection
• This function is used for when the heater notices a sudden drop in
temperature - associates that it may be caused by an open window
in the room where the cold air from outside enters and causes the
temperature to drop drastically - to avoid wasting electricity, the
heater It has an automatic stop working.
to restart to the same working mode before the
appliance stopped.
Ref. 07188
loading