Idiomas disponibles
Idiomas disponibles
3 Installation
3.1 Internal wire diagram
Thermal
Cut Out
Brown
L
Blue
N
Yellow/Green
E
3.2 installation instruction
1. This electrical water heater shall be installed
on a solid wall. If the strength of the wall can-
not bear the load equal to two times of the to-
tal weight of the heater filled fully with water, it
is then necessary to install a special support.
Incase of hollow bricks wall, ensure to fill it with
cement concrete completely.
2. After selecting a proper location, determine
the positons of the two install holes used for
expansion bolts with hook, Make two holes in
the wall with the corresponding depth by using
a chopping bit with the size matching the ex-
pansion bolts attached with the machine, insert
the screws, make the hook upwards, tighten the
nuts to fix firmly, and then hang the electrical
water heater on it (see Fig.2).
10 / EN
Thermal
Cut Out
Q
Q
WIRING DIAGRAM
Expansion bolt
(with hook)
(Fig.2)
Power
1
2
0
Thermostat
Power
Indicator
2
0
1
3. Install the supply socket in the wall. The require-
ments for the socket are as follows: 250V/10A,
single phase, three electrodes. It is recommend-
ed to placed the socket on the right above the
heater. The height of the socket to the ground
shall not be less than 1.8m (see Fig.3).If there
is fault on power cable, it should be replaced by
the manufacturers, agencies or qualified person
who is able to do this so as to ensure the safety.
L (Brown)
E (Yellow/Green)
N (Blue)
4. If the bathroom is too small, the heater can be
installed at another place. However, in order
to minimize the heat loss caused by the long
pipeline, the water heater is suggested to be
installed as close as possible to the outlet point.
Electric Storage Water Heater / User Manual
Q
Q
Thermostat
≥1.8m
(Fig.3)
Ground
