Idiomas disponibles
Idiomas disponibles
TROUBLESHOOTING
FAULT
Water leaks
Appliance does
not
turn on
Appliance water
pressure too
low
Detergent
cannot spray
out
Battery not
charging
Hose
Detergent
cannot spray
out
POSSIBLE CAUSE
The nozzle is not aligned
with the lance correctly
O-ring split/broken
Accessories are broken
Battery pack discharged?
The battery pack is not
connected correctly.
Filter blocked
The hose is trapped or
kinked
Inadequate water supply
The appliance /water source
height is too large
The power or water supply
is not on
The hose, gun, wand, or
nozzle is clogged
Battery pack too hot
Hose is clogged
Speed setting on Low
Deposits or restrictions in
the detergent system
REMEDY
Re-align the nozzle correctly
with the lance
Replace the accessory or
change the O-ring
Replace accessories
Fully charge the battery pack
Install the battery pack once
again
depress lock off
Clean the filter on the appliance
Straighten out the hose
Check water supply levels
Lower the appliance
Turn the power or water supply
on
Consult the troubleshooting list
below for these specific
parts and instructions
Allow the battery pack to cool
down before recharging
Remove the gun from hose and
hose from the unit. Flush the
hose with air or water to
dislodge debris.
Flush with clean water and
remove all debris
24
EN
