Idiomas disponibles
Idiomas disponibles
! Chemical hazard.
Do not open the battery pack. Protect the battery
from impact. If the accumulator electrolyte leaks,
skin contact must be avoided. If electrolyte contact
with the skin still occurs, rinse the affected area
immediately with water. If electrolyte gets into your
eyes, see a doctor immediately.
- Use protective equipment against noise, dust and
vibration !!!
SAVE THESE SAFETY INSTRUCTIONS !!!
DESCRIPTION
The tool is intended for manual lighting and lighting of
work spaces.
1 Switch
2 Tilting reflector
15. Accumulator /Li-ion/
16, Battery release button
17. Charging device
18. Battery status indicator
Battery and charger are not part of the delivery.
Pictograms
Pictograms listed on the product packaging:
a) Power supply
b) Accumulator
c) LEDs
USE AND OPERATION
ASIST tools are intended for home or hobby use only.
The manufacturer and importer do not recommend
using this tool in extreme conditions and under high
loads.
Any additional requirements must be the subject of
an agreement between the manufacturer and the
customer.
Inserting and removing the battery
1. Insert the charged battery into the tool handle until
it clicks into place
Check that the battery is securely seated
locked in place.
To remove the battery, press and hold the button on
the back of the battery and slide the battery out of the
battery slot.
Charging (B)
The battery must be charged before using the device
for the first time.
1. Insert the plug of the AC adapter into a standard
electrical outlet (230V).
2. Connect the charger to the battery charging socket.
3. Normal charging time is about 3-5 hour. The
battery and charger heat up during charging. It does
not indicate a malfunction of the device.
Warning:
Do not charge the battery for more than 6 hours.
Overcharging can shorten battery life.
4. After the battery is fully charged, turn off the
charger by disconnecting the AC adapter from the
mains.
5. If the battery is not in use, store it away from heat
sources.
Recharging the battery:
If the battery is completely discharged, charge it for
3-5 hour. Follow steps 1-5 of the battery charging
procedure. Do not recharge the battery repeatedly
after short use (less than 15 min.). You can extend
the life of the battery if you let it completely discharge
before charging.
CHECKING BATTERY CONDITION
Battery status can be checked using the battery
status indicator (8).
Press and hold the button on the battery status
indicator and the LED indicators will light up.
If 3 LED indicators light up (2 green, 1 red), the
device is fully charged. If 2 LEDs
indicator lights (1 green, 1 red) are lit, the device has
half capacity. If 1 LED indicator (1 red) lights up, the
device needs to be charged soon.
On and off
Insert the rechargeable battery into the tool.
Press the switch (1)
Turn off the light by releasing the switch (1).
Adjusting the angle of the tilting reflector
The tilting reflector shines horizontally in the basic
position.
From the initial position, it can be tilted downwards at
a maximum angle of 20° or upwards at a maximum
angle of 90°.
CLEANING AND MAINTENANCE
The tool is almost maintenance-free
• Prevent moisture from entering the inside of the tool
when cleaning.
Cleaning
• Always switch off the tool and remove the battery
37
