2
TO INSTALL BAGGER COM PO NENTS TO
TRACTOR
•
Remove discharge chute from rear of tractor. Unhook the
two (2) straps and pull chute out and away from tractor.
•
Remove the two (2) 3/8 nuts and flat washers from the
bolts at the tractor back plate.
1.
Dis charge Chute
2.
3/8 Nut
3.
Flat Washer
•
Using the nuts and flat washers removed from tractor
back plate, install the bagger support tube to the back
plate as shown. Tighten securely.
•
Install bagger support plugs into top of support tube.
1.
3/8 Lock nut
2.
Flat Wash er
3.
Support Tube
4.
Bolt
5.
Bagger Support Plug
•
Install the two upper support brack ets through the back
plate and to the chas sis using two each 3/8 x 19mm hex
bolts and 3/8 locknuts from parts bag. Tight en securely.
•
Assemble both support brackets to the outside of the
bagger support tube using two each 3/8 x 63,5mm hex
bolts, 13/32" I.D. flat washers and 3/8 locknuts from parts
bag. Tight en securely.
•
Replace discharge chute into rear opening of tractor.
Secure the chute with the two hook straps.
1.
Support Bracket
2.
3/8 Lock Nut
3.
3/8 x 63,5mm Hex
Bolt
4.
10,3mm (13/32")
flat washer
5.
Bolt
1
2
3
5
3
2
1
4
2
1
4
3
5
NOTE: The strap hook must go through the discharge chute
only. Do not allow the hook to enter the slot in the tractor
back plate. This will allow the dis charge chute to float with the
mower deck when moving on uneven terrain.
1.
Hook
2.
Discharge
Chute
3.
Back plate
slot
TO ASSEMBLE BAGGER
•
Unfold bag by pivoting front bagger tube all the way
forward and pressing the bottom vinyl binding onto the
tube.
1.
Front bagger
tube
2.
Vinyl binding
•
Inside the bag, install spreader bars and retainer springs
onto pins on both sides of bag as shown.
•
Press the vinyl bindings onto the sides of front bagger
tube.
3.
Spreader bars
4.
Retainer spring
5.
Vinyl binding
NOTE: For tractors with an electric dump system, refer to the
kit instructions for more assembly procedures.
24
2
1
2
4
5
4
1
3
3
5
