Idiomas disponibles
Idiomas disponibles
Dear Customer,
We thank you and congratulate you for choosing the quality and reliability of the GEROMIN GROUP products.
We hope you fully enjoy all the beneficial functions of our products and remain completely satisfied with them.
To ensure correct use of the product and its functioning over time, please read carefully, in its entirety, and keep this manual
which must be considered an integral part of the product. If you need any information, do not hesitate to contact our office
directly, a specialized technician will be at your complete disposal.
Before proceeding with the installation make sure that:
-
The installation must be carried out by qualified personnel in compliance with the legal provisions and specific national
regulations relating to hydraulic systems.
-
All local hydraulic and construction provisions required by current legislation on the matter are observed.
-
The following instructions are aimed at qualified personnel with the necessary experience to be able to handle the product
in complete safety.
-
The hydraulic preparation complies with the type of product to be installed.
-
The floor and supporting surface are flat, level, clean and compact.
-
The shower tray must be used in domestic environments at room temperature.
-
Check that the contents of the packaging comply with what was ordered (model, dimensions and colour).
-
Check that the shower tray is not damaged.
-
The product has not undergone deformations due to incorrect storage. Therefore, it is advisable to check using a bar or
metal ruler. A deformation of 2 mm per linear meter is within manufacturing tolerances and therefore does not represent
a defect. In the event of installation of a warped/deformed product, the warranty will be void. If installation is to take place
at a later time, place the shower tray in the cardboard until installation, taking care to position it as indicated in the
instructions.
-
To avoid water stagnation, the shower outlet must fall entirely inside the drainage basin, preferably as close as possible
to the drain. In case of incorrect installation, the warranty will be void.
The company declines all responsibility if the conditions below are not respected:
-
The shower trays can be supplied to measure or cut by the customer using grinders or circular saws with diamond discs.
The cut must always be straight and can be made both lengthwise and widthwise, also to create recesses to adapt the
shower tray to the walls.
-
The product must be installed by qualified or authorized personnel.
-
Certified materials must be used for installation.
-
Components of the product must not be modified or replaced with respect to the supply, nor must it be repaired by
unauthorized personnel.
-
The product is intended for use indoors and must not be installed outdoors.
-
The product must not be used independently by people with reduced motor, sensory and cognitive abilities, including
children, without adequate supervision.
-
The presence or use of electrical devices (radios, electric heaters, etc.) near the shower tray is dangerous.
-
When the surface of the shower tray is wet, the risk of slipping increases. Be especially careful when using soap,
shampoo, bath oil and other personal hygiene products.
GB
GENERAL INFORMATIONS
WARNINGS FOR INSTALLATION AND USE
05
